Advancing towards well-controlled full-wafer nanostencil lithography
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
This paper reports on the technology development and characterization of polyimide-based, microfluidic channels with integrated nanoporous membranes. A layer transfer and lamination technique is used to fabricate flexible microchannels from spin-on polyimi ...
A 2×2 microfluidic-based optical switch is proposed and demonstrated. The switch is made of an optically clear silicon elastomer, Polydimethylsiloxane (PDMS), using soft lithography. It has insertion loss smaller than 1 dB and extinction ratio on the order ...
A rapid and simple method to fabricate tiny shadow-masks and their use in multi-layer surface patterning with in situ micromechanical alignment is presented. Instead of using silicon micromachining with through-wafer etching to define the thin membrane wit ...
Patterning with lithographic processes requires processing steps including the use of resist spinning and chemical solvents for the development of resist. These steps cannot be applied to mechanical fragile and bio/chemically functional surface layers such ...
A process to fabricate functional polysilicon structures above large (4 x 4 mm(2)) thin (200 nm), very flat LPCVD silicon rich nitride membranes was developed. Key features of this fabrication process are the use of low-stress LPCVD silicon nitride, sacrif ...
Sub-micron scale lithography methods using deep UV, X-ray or electron beams will allow for further progress in integrated circuit hardware manufacturing. The drawback of these high-end patterning methods however is firstly, the high cost of the equipment, ...
A release technique that enables to lift microfabricated structures mechanically off the surface without using wet chemistry is presented. A self-assembled monolayer of dodecyltrichlorosilane forms a very uniform 1.5-nm-thick anti-adhesion coating on the s ...
This paper describes a method of thin film and MEMS processing which uses self-assembled monolayers as ultra-thin organic surface coating to enable a simple removal of microfabricated devices off the surface without wet chemical etching. A 1.5-nm thick sel ...
