Multiple glycerol shocks increase the calcium phosphate transfection of non-synchronized CHO cells

The exposure of CHO DG44 cells to an osmotic shock, after DNA uptake, results in a cellular volume decrease of approx. 55%. Repetitive osmotic shocks targeted different sub-populations of cells as was demonstrated using two different fluorescent reporter genes. Also the exposure of a calcium phosphate-DNA coprecipitate to high osmolarity in vitro caused the release of the DNA from the precipitate. The results demonstrate the importance of the osmotic shock on the efficient delivery of plasmid DNA to the nucleus of CHO cells following calcium phosphate-mediated transfection.

The use of RNA interference to increase PEI-mediated transient gene expression in mammalian cells

Martin Bertschinger

DNA uptake by polyethylenimine (PEI)-mediated transfection was investigated in Chinese hamster ovary (CHO DG44) cells. Rapid DNA uptake was observed with the maximum occurring during the first 45-60 min after addition of PEI-DNA complexes to cells. With longer incubation times, the aggregation of PEI-DNA particles reduced the rate of DNA uptake. At early times after transfection, the kinetics of DNA uptake were constant, suggesting that the limiting factor to PEI transfection was the rate of endocytosis. The most efficient transfection with PEI was observed at a density of 2 x 106 cells/ml and at a PEI:DNA ratio of 2:1 (w/w). DNA uptake at higher PEI:DNA ratios was also efficient, but the toxicity of PEI decreased the recombinant protein yield. The optimal PEI:DNA ratio was found to be related to the number of cells in the culture. Once in the cell, PEI:DNA particles must be disassembled to allow transcription of the recombinant gene. Here their disassembly was investigated using a simple in vitro assay. The particles were formed with either a linear (25 kDa or JetPEITM) or a branched PEI (2, 25, or 750 kDa) and then mixed with varying amounts of a competitor (RNA, DNA, or heparin). The amount of plasmid DNA released from particles was determined by agarose gel electrophoresis or spectroscopy. The stability of the particles to changes in pH, osmolarity, and the PEI:DNA ratio was also determined. Either the presence of heparin or high salt concentrations (1-2 M) yielded complete particle disassembly for all PEIs tested. The addition of RNA to particles formed with linear PEIs or branched 2 kDa PEI resulted in the rapid release of all the plasmid DNA, even at an RNA concentration of 50 µg/ml. However, the presence of RNA at concentrations up to 400 µg/ml induced only partial disassembly of particles formed with branched PEIs of 25 or 750 kDa. In the presence of competitor DNA, slow particle disassembly was observed with particles made with linear 25 kDa PEI, JetPEI, and branched 2 kDa PEI, but DNA release was not seen for particles made with branched PEIs of higher molecular weight. The presence of BSA only resulted in partial disassembly of PEI-DNA particles, and DNA release was not observed after the exposure of particles to acidic pH as low as 3. For all the PEIs tested, their stability increased as the PEI:DNA ratio increased. It was concluded from these studies that branched PEIs have a higher affinity for DNA than linear PEIs and that the intracellular disassembly of PEI-DNA particles may involve interactions between PEI and cellular RNA. In the second part of the work, RNA interference (RNAi) was used to enhance transient gene expression by knockdown of two different mRNAs, the E1A mRNA in human embryonic kidney 293 EBNA (HEK293E) cells and the ube2i mRNA in CHO DG44 cells and HEK293 cells. HEK293 cells are transformed with the adenovirus E1A and E1B genes. Because the E1A proteins function as transcriptional activators or repressors, they may have a positive or negative effect on transient transgene expression in this cell line. Suspension cultures of HEK293 cells were co-transfected with a reporter plasmid expressing the GFP gene and a plasmid expressing a short hairpin RNA (shRNA) targeting the E1A mRNAs for degradation by RNAi. The presence of the shRNA in HEK293E cells reduced the steady state level of E1A mRNA up to 75% and increased transient GFP expression from either the elongation factor-1α (EF-1α) promoter or the human cytomegalovirus (HCMV) immediate early promoter up to 3-fold. E1A mRNA depletion also resulted in a 2-fold increase in transient expression of a recombinant IgG in suspension cultures when the IgG light and heavy chain genes were driven by the EF-1α promoter. These results demonstrated that E1A has a negative effect on transient gene expression in HEK293E cells. Efficient RNAi-mediated depletion of ube2i mRNA in CHO DG44 cells was accomplished by co-expression of 2 shRNAs targeting two distinct sides in the ube2i mRNA, whereas knockdown with only one of the shRNAs at a time was insufficient for reducing ube2i mRNA levels. The reduction of the ube2i mRNA level in CHO DG44 cells was shown to enhance transient GFP expression 2-fold and IgG expression 2.5-fold. For these experiments, the GFP gene was under the control of the CMV IE promoter and the IgG light and heavy chain genes were under the control of the human EF-1α promoter. Thus, the enhancement of transient gene expression resulting from ube2i mRNA depletion was not promoter-dependent. These results demonstrated that sumoylation has a negative effect on transient gene expression in CHO DG44 and HEK293E cells.

EPFL2006

Generation of recombinant Chinese hamster ovary cell lines by microinjection

Madiha Derouazi, Philippe Girard, Martin Jordan, Florian Maria Wurm

Microinjection is a gene transfer technique enabling partial control of plasmid delivery into the nucleus or cytoplasm of cultured animal cells. Here this method was used to establish various recombinant mammalian cell lines. The injection volume was estimated by fluorescence quantification of injected fluorescein isothyocynate (FITC)-dextran. The DNA concentration and injection pressure were then optimized for microinjection into the nucleus or cytoplasm using a reporter plasmid encoding the green fluorescent protein (GFP). Nuclear microinjection was more sensitive to changes in these two parameters than was cytoplasmic microinjection. Under optimal conditions, 80-90% of the cells were GFP-positive 1 day after microinjection into the nucleus or the cytoplasm. Recombinant cell lines were recovered following microinjection or calcium phosphate transfection and analyzed for the level and stability of recombinant protein production. In general, the efficiency of recovery of recombinant cell lines and the stability of reporter protein expression over time were higher following microinjection as compared to CaPi transfection. The results demonstrate the feasibility of using microinjection as a method to generate recombinant cell lines. .

Kluwer Academic Publishers, Springer2006

Accelerating the development time of recombinant mammalian cell lines producing high titers of protein therapeutics

Sébastien Chenuet

The forthcoming arrival on the market of numerous protein therapeutics that require high clinical doses will foster the need for high-producing mammalian cell lines. Furthermore, pressures to reduce the development time for new therapeutics has meant more emphasis on efforts to accelerate the process that yields such cell lines. The objective of this thesis work was to develop methods to decrease the time needed to generate stable and high producing mammalian cell lines. This could be achieved by overcoming some of the major limitations that hamper the process of cell lines development. The host systems chosen for this study were Chinese hamster ovary (CHO DG44) and baby hamster kidney (BHK-21). The recombinant proteins used as reporters were the green fluorescent protein (GFP) and a human anti-Rhesus D IgG. One limitation hampering the development of cell lines producing high recombinant protein titers is the extensive variability of transgene expression within a transfected population as a result of the gene delivery process. This decreases the reproducibility of the generation of high producing cell lines. A direct comparison of two gene chemical delivery methods, polyethylenimine (PEI)- and calcium phosphate (CaPO4)-mediated transfection, with a mechanical method (microinjection) provided some insights into ways to overcome this limitation. Indeed, a correlation was observed between the amount of plasmid DNA delivered into cells and the specific productivity of the recovered recombinant cell lines. Hence, by increasing the amount of DNA delivered per cell, IgG-producing clones with specific productivities up to 22 pg/cell/day were recovered with a high efficiency. A second limitation is the time needed to assure the stability and clonality of cell lines by current analytical methods. This was overcome by using GFP as a reporter for the level of production of a co-expressed therapeutic protein. The co-transfection of plasmids individually carrying the GFP and IgG heavy (Hc)- and light chain (Lc) genes, resulted in integration of all three plasmids at the same site in the cell's genome. As a consequence, the stability of GFP expression correlated with that of IgG expression. This proved to be advantageous finding and eliminating unstable cell lines early in the process of selection. As a consequence, it was possible to derive in serum-free medium clones with a specific productivity almost 6 times higher than that of clones derived from transfection performed with the IgG Hc and Lc vectors only. A third limitation to the rapid recovery of stable cell lines is the time devoted to the cultivation of transfected cells in selective medium, normally one month. Here, the time of selection was shortened to one week by increasing the stringency of the selective pressure. The results from studies of plasmid integration kinetics by fluorescence in situ hybridization (FISH) showed that the increased stringency of selection decreased the time needed to enrich a transfected population with recombinant cells. Furthermore, stable clones were shown to be present in this population after one week of selection and could be uncovered by identifying patterns of GFP expression predictive of production stability. By limiting the screening to clones exhibiting these stable patterns of GFP expression, the number of clones needed in order to isolate stable cell lines producing high IgG titers could be dramatically reduced. In conclusion, these results combined together provided a new procedure to isolate within a week of the start of selection, stable and high-producing clones. 30-40% of the clones isolated using this procedure were stable for at least three months and their average specific productivity was 29 pg/cell/day.