Geometric Alignments of the Subgrid-Scale Force in the Atmospheric Boundary Layer

Chad Higgins, Charles Vivant Ignacio Meneveau, Marc Parlange
2009
Journal paper

Abstract

priori tests of subgrid-scale (SGS) models for large-eddy simulations (LES). The experimental arrangements and data collected have facilitated studies of variables such as the filtered strain rate, SGS stress and dissipation, and the eddy viscosity coefficient. However, the experimental set-ups did not permit analysis of the divergence of the SGS stress (the SGS force vector), which is the term that enters directly in the LES momentum balance equations. Data from a field experiment (SGS2002) in the west desert of Utah, allows the calculation of the SGS force due to the unique 4 × 4 sonic anemometer array. The vector alignment of the SGS force is investigated under a range of atmospheric stabilities. The eddy viscosity model is likely aligned with the measured SGS force under near-neutral and unstable conditions, while its performance is unsatisfactory under stable conditions.

Official source

https://infoscience.epfl.ch/record/138912?ln=en

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Related concepts

Related publications

, ,

In field experiments designed to study subgrid-scale parameterizations for large eddy simulation, the flow field is often measured and then filtered in two-dimensional planes. This two-dimensional filtering serves as a surrogate for three-dimensional filtering. The question of whether this will yield accurate results in subgrid-scale (SGS) models is addressed by analyzing data from a field experiment in which 16 sonic anemometers were deployed in a four by four grid. The experiment was held in July 2002 at the Surface Layer Turbulence and Environmental Science Test (SLTEST) facility in the Utah West Desert. The full SGS stress tensor and its parameterizations using both two- and three-dimensional filterings are obtained. Comparisons are given between two- and three-dimensional filterings of the field measurements based on probability density functions (PDFs) and energy spectra of the SGS stress elements. The PDFs reveal that quantities calculated with two-dimensional filtering exhibit greater intermittency than those computed with three-dimensional filtering at the same scale. From the spectra it is observed that the different filtering methods result in similar behavior, but that spectra of SGS stress components computed with a threedimensional filter roll off at a slightly lower wavenumber than those computed with a two-dimensional filter. The PDFs and spectra of the stresses calculated with two- and three-dimensional filters can be made to collapse by reducing the three-dimensional filter scale according to Δ3-D = 0.84Δ2-D. Geometric alignment analyses are performed for the SGS heat flux, SGS stress, and filtered strain rate for the cases of stable, near-neutral, and unstable atmospheric stabilities. Under unstable and near-neutral atmospheric stability, two-dimensional filtering yields acceptable results; however, under stable atmospheric stability, a new approach is recommended and delineated.

2007

, ,

Field measurements in the atmospheric boundary layer were carried out to identify the effect of atmospheric stability on subgrid-scale physics for large-eddy simulation. The basic instrumentation setup consisted of 12 three-dimensional sonic anemometers arranged in two parallel horizontal arrays (seven sensors in the lower array and five sensors in the upper array). Data from this setup are used to compute the subgrid-scale (SGS) heat fluxes and SGS dissipation of the temperature variance under stable and unstable stability conditions. The relative contribution of the SGS vertical flux to the total turbulent flux increases when going from unstable to stable conditions. The relative importance of negative SGS dissipation (backscatter) events becomes larger under stable conditions. The model coefficients for two well-known SGS models (eddy-viscosity and non-linear) are computed. Model coefficients are found to depend strongly on stability. Under both stable and unstable conditions, large negative SGS dissipation is associated with the onset of ejection events while large positive SGS dissipation tends to occur during the onset of sweep events. These findings are also supported by conditionally sampled 2D velocity and temperature fields obtained using the 12 anemometers placed in a vertical array.

2001

Modeling Flow around Bluff Bodies and Predicting Urban Dispersion Using Large Eddy Simulation

Charles Vivant Ignacio Meneveau, Marc Parlange

Modeling air pollutant transport and dispersion in urban environments is especially challenging due to complex ground topography. In this study, we describe a large eddy simulation (LES) tool including a new dynamic subgrid closure and boundary treatment to model urban dispersion problems. The numerical model is developed, validated, and extended to a realistic urban layout. In such applications fairly coarse grids must be used in which each building can be represented using relatively few grid-points only. By carrying out LES of flow around a square cylinder and of flow over surface-mounted cubes, the coarsest resolution required to resolve the bluff body’s cross section while still producing meaningful results is established. Specifically, we perform grid refinement studies showing that at least 6-8 grid points across the bluff body are required for reasonable results. The performance of several subgrid models is also compared. Although effects of the subgrid models on the mean flow are found to be small, dynamic Lagrangian models give a physically more realistic subgridscale (SGS) viscosity field. When scale-dependence is taken into consideration, these models lead to more realistic resolved fluctuating velocities and spectra. These results set the minimum grid resolution and subgrid model requirements needed to apply LES in simulations of neutral atmospheric boundary layer flow and scalar transport over a realistic urban geometry. The results also illustrate the advantages of LES over traditional modeling approaches, particularly its ability to take into account the complex boundary details and the unsteady nature of atmospheric boundary layer flow. Thus LES can be used to evaluate probabilities of extreme events (such as probabilities of exceeding threshold pollutant concentrations). Some comments about computer resources required for LES are also included.

2006

Modeling Flow around Bluff Bodies and Predicting Urban Dispersion Using Large Eddy Simulation

Charles Vivant Ignacio Meneveau, Marc Parlange

2006