Structural behavior of multifunctional GFRP joints for concrete structures

Thomas Keller, Florian Riebel
2009
Journal paper

A multifunctional all-FRP joint has been developed for the transfer of bending moments and shear forces in thermal insulation sections of concrete slab structures used in building construction. Tensile forces from moments are transferred by horizontal GFRP bars, while a pultruded cellular GFRP element transfers the compression forces. The shear forces are transferred by inclined GFRP bars and the webs of the GFRP element. The new joint considerably increases energy savings for buildings due to the low thermal conductivity of GFRP materials. The quasi-static behavior of the joint at the fixed support of cantilever beams was investigated. Two parameters were studied: shear- or moment-dominated loading mode and concrete strength. Results show that the all-FRP joint does not play a critical role at the ultimate limit state. Ductile failure occurs through concrete crushing. The GFRP bars lead to a significant improvement in joint performance compared with similar joints comprising steel bars. Higher concrete strength does not, however, significantly improve the ultimate load. [All rights reserved Elsevier]

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Thomas Keller, Florian Riebel
2009
Journal paper

Abstract

Official source

https://infoscience.epfl.ch/record/139014?ln=en

About this result

Related concepts (2)

Reinforced concrete

Reinforced concrete, also called ferroconcrete, is a composite material in which concrete's relatively low tensile strength and ductility are compensated for by the inclusion of reinforcement having higher tensile strength or ductility. The reinforcement is usually, though not necessarily, steel bars (rebar) and is usually embedded passively in the concrete before the concrete sets. However, post-tensioning is also employed as a technique to reinforce the concrete. In terms of volume used annually, it is one of the most common engineering materials.

Concrete slab

A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel-reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving . In many domestic and industrial buildings, a thick concrete slab supported on foundations or directly on the subsoil, is used to construct the ground floor. These slabs are generally classified as ground-bearing or suspended.