Structural Response of R-UHPFRC - RC Composite Members Subjected to Combined Bending and Shear
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
Due to their aesthetic and structural advantages, tubular space truss structures are enjoying increasing popularity in modern bridge construction. The use of cast steel nodes for the joints between the circular hollow section members is also becoming incre ...
This paper reports on the composite action developed between pultruded FRP bridge deck systems and the supporting main girders for road bridges. Presented are requirements that an FRP deck must satisfy in order to function as part of the upper chord of the ...
The extremely low permeability of Ultra High Performance Fibre Reinforced Concretes (UHPFRC) associated to their outstanding mechanical properties make them especially suitable to locally "harden" reinforced concrete structures in critical zones subjected ...
Fiber-reinforced polymer (FRP) composites offer several advantages in relation to traditional materials, such as high specific strength, good corrosion resistance, low thermal conductivity and rapid component installation. Despite the great potential of th ...
A multifunctional hybrid glass fiber-reinforced polymer (GFRP)/steel joint has been developed for the transfer of compression and shear forces in thermal insulation sections of concrete slab structures used in building construction. The new pultruded cellu ...
To improve the reduced available experimental data on the load capacity of full scale bridge deck slabs, 3 tests on a large scale bridge cantilever (10 x 4.2 m) were done. The cantilevers were tested under 4, 2 and 1 concentrated loads simulating traffic w ...
Up until today reinforced concrete has been used in most cases for the manufacturing of bridge decks. Depending on the quality of the work carried out, defects can already occur after only a few years. These defects mostly appear in the form of corrosion o ...
This paper describes the behavior of hybrid girders consisting of fiber-reinforced polymer (FRP) bridge decks adhesively connected to steel main girders. Two large-scale girders were experimentally investigated at the serviceability and ultimate limit stat ...
Analytical prediction methods for axial stresses and deflections at the serviceability limit state and for ultimate failure loads are proposed for hybrid bridge girders consisting of FRP bridge decks adhesively bonded to steel girders. The methods allow fo ...
When building new bridge structures, or widening or replacing existing bridges, the duration of on site work has a significant influence not only on the costs, but also on the potentially harmful effects (noise, pollution, traffic jam, deviation) of the co ...
