Recrystallization characteristics of a fine grained copper alloy
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
The demand for metal alloys with superior structural performance in industrial applications continues to increase, as does the need for more-energy efficient materials and methods. Many materials that are otherwise attractive for structural applications ar ...
A current goal driving alloy development is the identification of alloy compositions for high temperature applications but with the additional requirement of sufficient ductility at ambient temperatures. Multicomponent, single-phase, polycrystalline High E ...
The microstructural evolution of the two austenitic alloys Fe-20Mn-3Al-0.7C wt pct and Fe-20Mn-6Al-0.7C wt pct when different thermal and thermomechanical treatments are performed has been studied. To this end, a generic industrial die of 100 ton capacity ...
This study presents a thermomechanical processing concept which is capable of exploiting the full industrial application potential of recently introduced AlMgZn(Cu) alloys. The beneficial linkage of alloy design and processing allows not only to satisfy th ...
The recrystallization behavior of an Al-Cu-Mg alloy is investigated in multi-directionally forged over-aged and solution treated alloys, during non-isothermal annealing. Deformation and non-isothermal annealing are performed with a Gleeble 3800 thermo-mech ...
High-head steel lined pressure tunnels and shafts may be considered as critical infrastructures especially when rock overburden is small. In the case of lining failure, catastrophic damages can occur when a large amount of water can reach the steep valley ...
Extreme loading scenarios such as earthquakes, exceptional wind gusts or tides are characterized by very high amplitude and multidirectional cyclic loads applied to a structure. Ultra Low Cycle Fatigue (ULCF) arises in such cases and can be summarily defin ...
Annealing of supersaturated AA3xxx alloys at low temperatures usually results in sluggish recrystallization kinetics. This is due to the joint effect of the following factors: low nucleation rate, reduced grain boundary mobility, and large amount of fine p ...
Using different homogenization treatments, different initial microchemistry conditions in terms of solid solution levels of Mn, and number densities and sizes of constituents and dispersoids were achieved in an Al-Mn-Fe-Si model alloy. For each homogenized ...
The effects of thermal treatments on a Co-Ni-Cr super-alloy in the temperature range from 250 degrees C to 900 degrees C, resulting in secondary hardening, have been studied by Mechanical Spectroscopy. The simultaneous evolution of the internal friction sp ...