Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
The eutectic micro-constituent in SnAgCu solder governs the deformation behavior of the joint as it shows better deformation resistance than the Sn dendrites and occupies a high volume percentage of the whole solder. The main scope of this study is to deve ...
The compatibility of polydimethylsiloxane (PDMS) channels with certain solvents is a well known problem of soft lithography techniques, in particular when it leads to the swelling of the PDMS blocks. However, little is known about the modification of micro ...
The overall aim of this thesis has been to assess the potential of latex-based technologies for the preparation of polymer/clay nanocomposites. The key feature of latex-based technologies is that they offer the possibility of improved control of the final ...
Hot tearing is one of the most severe defects observed in castings, e.g. in billets or sheet ingots of aluminum alloys produced by DC casting. It is due to both tensile strains and a lack of interdendritic feeding in the mushy zone. In order to predict thi ...
Nanocrystalline metals have been an area of great interest in recent years due to their enhanced characteristics. One of the most striking is implied by the Hall-Petch relation: with decreasing grain size the material becomes stronger. This promise is fulf ...
Deformation mechanisms in nanocrystalline electrodeposited Ni (26 nm) and Ni-Fe (12 nm) are studied by strain rate sensitivity experiments and in situ mechanical testing during X-ray diffraction. We find a relatively low strength for Ni-Fe, which may be as ...
In finite element simulations dedicated to the modelling of microstructure evolution, the mesh has to be fine enough to: (i) accurately describe the geometry of the constituents; (ii) capture local strain gradients stemming from the heterogeneity in materi ...
Indentation testing of a finite poroelastic layer is considered. Finite element modeling was used to investigate spherical contact creep tests, with emphasis on the influence of layer thickness and of finite rise time on the time-dependent deformation. Thi ...
In this work, we study in detail the sensing characteristics of piezoresistive force sensors based on structured LTCC (Low Temperature Co-fired Ceramic) cantilevers carrying a thick-film piezoresistive bridge. These devices show much improved sensitivity c ...
The deformation mechanisms of silicon {001} surfaces during nanoscratching were found to depend strongly on the loading conditions. Nanoscratches with increasing load were performed at 2 μm/s (low velocity) and 100 μm/s (high velocity). The load-penetratio ...