Punching of Flat Slabs with Large Amounts of Shear Reinforcement
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
Molecular dynamics simulations were performed to study the deformation mechanisms of < 110 >-oriented, faceted Cu and Au nanowires under bending along three different crystallographic directions. Independent of the bending direction, the stress field is ch ...
We investigate the influence of the reduction of width along the stretching direction, the so-called neck-in effect, on the draw resonance instability in Newtonian film casting using a linear stability analysis of a model of reduced dimensionality includin ...
The Critical Shear Crack Theory (CSCT) is a consistent approach used for shear design of one- and two-way slabs failing in shear and punching shear respectively. The theory is based on a mechanical model allowing to determine the amount of shear force that ...
Code design of Unreinforced Masonry (URM) buildings is based on elastic analysis, which requires as input parameter the effective stiffness of URM walls. Current approaches estimate the effective stiffness as fixed ratio of the gross sectional stiffness bu ...
Continuous-fiber ceramic matrix composites (CMCs) are of interest as hot-section components in gas turbine engines due to their refractoriness and low density relative to metallic alloys. In service, CMCs will be subjected to spatially inhomogeneous temper ...
Deformation-dependent punching shear resistance often constitutes the decisive design criterion for reinforced concrete slabs supported by columns. The increasing number of aging structures exhibiting insufficient punching resistance and detailing deficien ...
Due to the accumulation of traffic, the railway components are affected by the induced stresses. As a result, the geometry of the railways is degraded over time. The degradation occurs either through the partial loss of the track's geometry or through the ...
This paper investigates experimentally and numerically the biaxial flexural behaviour of thin circular slab specimens made of Ultra High Performance Fibre Reinforced Cementitious Composite (UHPFRC). The circular slab specimens represent an external tensile ...
We present results from an experimental and numerical investigation on the compression, and consequent buckling, of a slender rod constrained inside a horizontal cylinder. An experimental model system is developed to systematically study the sequence of in ...
The electro-mechanical sensing properties of freestanding monolayered membranes of dodecanethiol coated 7 nm gold nanoparticles (NPs) are investigated using AFM force spectroscopy and conductive AFM simultaneously. The electrical resistance of the NP membr ...
