Ratio of mirror zone depth to flaw depth after failure of glass beams
Related publications (32)
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
We propose and experimentally demonstrate a device in which common-path interferometry combined with off-axis holographic geometry is used to realize a digital holographic camera which can be attached to the camera port of a conventional transmission micro ...
In this thesis, we explore a combination of analog and digital holographic techniques to demonstrate high speed quantitative phase imaging (QPI) using low coherence (broad bandwidth) light sources. Off-axis digital holographic microscopy is inherently a co ...
A reliable assessment of the edge strength becomes an important issue when designing structural glass elements in buildings. However, in the literature the edge strength of glass, dependent on the edge quality, is not well documented. Therefore, in this st ...
During their lifetime, glass panels are repetitively exposed to thermal stresses. These thermal stresses result from temperature differences within the panel, which most notably cause the edges of the panels to be stressed in tension. When these thermal st ...
A micro particle shadow velocimetry (mu PSV) system based on back-lit illumination and forward scatter observation of light from non-fluorescent particles has been developed. Relatively high luminous efficiencies and particle image contrasts were achieved ...
This paper focuses on the numerical modelling of SentryGlas-laminated reinforced glass beams. In these beams, which have been experimentally investigated in preceding research, a stainless steel reinforcement section is laminated at the inner recessed edge ...
In literature, the experimental validation of a glass edge strength model is lacking. Therefore, in this study, an edge strength model was established and validated. The short-term parameters of the edge strength model, i.e. the flaw geometry and depth, we ...
We present the use of a microlens array in combination with a conventional optical microscope set-up for the detection of single nanoparticles (NPs) in fluid medium. Optically transparent dielectric microspheres are patterned in a microfabricated well arra ...
In modern buildings, glass is increasingly used as a load-carrying material in structural components, such as glass beams. For glass beams especially the edge strength of glass is important. However, the strength of glass is not a material constant but dep ...
This paper investigates the effects of glass type (annealed, heat-strengthened and fully tempered), reinforcement percentage (hollow section and full section) and beam size (1.5 and 3.2 m) on the structural response of SG-laminated reinforced glass beams. ...