Quench induced residual stress prediction in heat treatable 7xxx aluminium alloy thick plates using Gleeble interrupted quench tests
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
Copper and copper alloys typically experience a sharp loss in ductility at intermediate temperature, induced by grain boundary damage and fracture processes. The susceptibility of the material to intermediate temperature embrittlement is, as a result, stro ...
Modeling of the constitutive behavior was undertaken for Fe- Cr-C tempered martensitic alloys. Tensile tests were carried out at room temperature and constant nominal strain rate. In order to obtain a fully martensitic structure with different prior austen ...
As the upper temperature for use of reduced activation ferritic/martensitic steels is presently limited by a drop in mechanical strength at about 550 degrees C, Europe, Japan and the US are actively researching steels with high strength at higher operating ...
In the quest of materials for the first wall of the future fusion reactor, it has been shown that oxide dispersion strengthened (ODS) ferritic / martensitic (F/M) steels appear to be promising candidates. The inherent good mechanical properties supported b ...
The tensile mechanical response of three semi-solid as-cast aluminum alloys - AA3104, AA6111, and CA31218 (an alloy similar in composition to AA3003) - was measured between a fraction solid f(s) similar to 0.85 and f(s) similar to 1 in order to establish t ...
Ternary Au-Cu-Pt alloys, of unequal gold and copper atomic contents and containing 2.5 wt.% Pt, are ordered isothermally at 250 or 400 degrees C after annealing at 650 degrees C and quenching in water. The alloys are characterized by transmission electron ...
An argon gas atomized, pre-alloyed Fe-14Cr-2W-0.3Ti (wt.%) reduced activation ferritic (RAF) steel powder was mechanically alloyed with 0.3wt.% Y2O3 nano-particles in an attritor ball mill and consolidated by hot isostatic pressing at 1150 °C under a press ...
The rheological behavior of a solidifying alloy is modeled by considering the deforming material as a viscoplastic porous medium saturated with liquid. Since the solid grains in the mush do not form a fully cohesive skeleton, an internal variable that repr ...
This paper describes the microstructure, tensile properties and Charpy impact resistance of a reduced activation oxide dispersion strengthened ferritic steel Fe-14Cr-2W-0.3Ti-0.3Y(2)O(3) produced by mechanical alloying of a pre-alloyed, gas atomised steel ...
In liquid metal spallation targets such as the MEGAPIE (the megawatt pilot experiment) target and the future ADS (accelerator driven system) spallation targets, which utilize liquid lead-bismuth eutectic (LBE) as the target material, liquid metal embrittle ...
