Crack tip blunting and cleavage under dynamic conditions
Related publications (43)
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
Even though friction affects everyday life in many ways, it is still one of the biggest mysteries of physics. Friction is a truly multi-scale phenomenon with a large variety of processes acting at various length and time scales. In recent years, much atten ...
Size effect has been theoretically and experimentally acknowledged as a phenomenon influencing the shear and punching shear strength of concrete structures, with reducing unitary shear strength for increasing member sizes. For members failing in shear, as ...
High-head steel lined pressure tunnels and shafts may be considered as critical infrastructures especially when rock overburden is small. In the case of lining failure, catastrophic damages can occur when a large amount of water can reach the steep valley ...
As jointed rocks consist of joints embedded within intact rock blocks, their behavior depends on the behaviors of the joints and the intact rock blocks. In a jointed rock, there are two levels of heterogeneity within the jointed rocks due to the difference ...
Extreme loading scenarios such as earthquakes, exceptional wind gusts or tides are characterized by very high amplitude and multidirectional cyclic loads applied to a structure. Ultra Low Cycle Fatigue (ULCF) arises in such cases and can be summarily defin ...
Shear fatigue of reinforced concrete members without transverse reinforcement has been observed to be potentially governing for the strength of some structural members subjected to large live loads of repetitive nature (as traffic, wind or wave actions). A ...
Five different grain sizes are produced in 0.17 wt% carbon steel using varying rates of cooling from austenitization temperatures. Controlled furnace cooling from 1100 °C and 950 °C produces coarse ferrite grains of 40 µm and 32 µm diameter, respectively, ...
The aim of the present thesis is to provide a numerical tool for the mechanical modeling of dynamic failure in concrete. This widely used construction material is characterized by a non-linear failure behavior, which is consequently difficult to describe w ...
Wear of materials is a very complex phenomenon due to its tight correlation with all the other phenomena that take place at the interface of two bodies interacting with one another, like friction, contact and lubrication. When two opposing surfaces slide o ...
Available acceptance and rejection criteria for discontinuities in steel components of a welded assembly focus only on a minimum limit for the steel fracture toughness and a maximum limit for the size of the discontinuity. However, other critical parameter ...