Strain-induced dissolution of Y-Ti-O nano-oxides in a consolidated ferritic oxide dispersion strengthened (ODS) steel
Graph Chatbot
Chat with Graph Search
Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
In order to deeply understand the high temperature deformation behaviors of Cu-0.23%Al2O3 (volume fraction) alloy, the changes of flow stress and microstructure for this alloy after deformation at high temperatures were investigated by using the Gleeble-15 ...
Copper and copper alloys typically experience a sharp loss in ductility at intermediate temperature, induced by grain boundary damage and fracture processes. The susceptibility of the material to intermediate temperature embrittlement is, as a result, stro ...
In the quest of materials for the first wall of the future fusion reactor, it has been shown that oxide dispersion strengthened (ODS) ferritic / martensitic (F/M) steels appear to be promising candidates. The inherent good mechanical properties supported b ...
Thermonuclear fusion of light atoms is considered since decades as an unlimited, safe and reliable source of energy that could eventually replace classical sources based on fossile fuel or nuclear fuel. Fusion reactor technology and materials studies are i ...
The microstructure, chemical and phase composition of the hard Ni-P-Ti layer formed on the Ti-6Al-4V alloy after duplex surface treatment were investigated by light microscopy, X-ray diffraction, scanning electron microscopy and analytical/high-resolution ...
The microstructural characterization of two titanium alloys, Ti5Al2.5Sn and Ti6Al4V, was performed. These alloys were selected as representatives of the alpha and alpha + beta titanium families, to investigate their possible application as structural mater ...
Modeling of the constitutive behavior was undertaken for Fe- Cr-C tempered martensitic alloys. Tensile tests were carried out at room temperature and constant nominal strain rate. In order to obtain a fully martensitic structure with different prior austen ...
Oxide dispersion strengthened steels based on the ferritic/martensitic steel EUROFER97 are developed. The reinforcing particles dispersed in the matrix of EUROFER97 are made of yttria and yttrium titanium oxides. Microstructure is investigated by transmiss ...
The aim of this paper is to report the very first in situ observations of the deformation behaviour of an Al-Cu alloy in the semisolid state by using ultrafast, high-resolution X-ray microtomography. It is shown that this deformation is non-homogeneous and ...
Aluminium-5 wt.% magnesium open cell foam produced by replication and tested in tension at 300, 350 or 450 degrees C creeps at rates between 10(-3) and 10(-8) s(-1). The behaviour of the foam matches that of the alloy from which it is made: three-power law ...
