Publication

Microwave plasma-assisted reactive HiPIMS of InN films: Plasma environment and material characterisation

Abstract

This work focuses on the low temperature fabrication process of InN thin films via microwave plasma-assisted reactive high power impulse magnetron sputtering (MAR-HiPIMS). The influence of microwave plasma on the HiPIMS discharge process at various nitrogen flows and microwave powers was monitored and characterised through in situ diagnostics, including following HiPIMS I(V,t) curves, optical emission spectroscopy (OES), as well as performing time-resolved Langmuir probe and time-of-flight mass spectroscopy (ToF-MS) measurements. This was followed by the deposition of InN films via standard reactive HiPIMS (reference sample) and MAR-HiPIMS and their characterisation via X-ray diffraction (XRD), reflectometry (XRR), as well as scanning and transmission electron microscopy (SEM, TEM). It was found that the microwave plasma facilitates the dissoci-ation/activation of nitrogen species and supplies seed electrons to the magnetron discharge plasma. Furthermore, the energy of the incoming ions was determined via ToF-MS, and it was possible to identify their plasma origin and temporal behaviour. The produced R-HiPIMS sample was highly metallic, with no nitride phase detected. The MAR-HiPMS film, however, was stoichiometric and exhibited (0002) direction texturing, with an optical bandgap of approx. 1.5 eV, electron concentration of 2.72 x 1020 cm -3 and electron mobility of 7.16 cm2V- 1s- 1 (in the range for polycrystalline InN).

About this result
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Related concepts (33)
Time-of-flight mass spectrometry
Time-of-flight mass spectrometry (TOFMS) is a method of mass spectrometry in which an ion's mass-to-charge ratio is determined by a time of flight measurement. Ions are accelerated by an electric field of known strength. This acceleration results in an ion having the same kinetic energy as any other ion that has the same charge. The velocity of the ion depends on the mass-to-charge ratio (heavier ions of the same charge reach lower speeds, although ions with higher charge will also increase in velocity).
Inductively coupled plasma atomic emission spectroscopy
Inductively coupled plasma atomic emission spectroscopy (ICP-AES), also referred to as inductively coupled plasma optical emission spectroscopy (ICP-OES), is an analytical technique used for the detection of chemical elements. It is a type of emission spectroscopy that uses the inductively coupled plasma to produce excited atoms and ions that emit electromagnetic radiation at wavelengths characteristic of a particular element. The plasma is a high temperature source of ionised source gas (often argon).
Electron mobility
In solid-state physics, the electron mobility characterises how quickly an electron can move through a metal or semiconductor when pulled by an electric field. There is an analogous quantity for holes, called hole mobility. The term carrier mobility refers in general to both electron and hole mobility. Electron and hole mobility are special cases of electrical mobility of charged particles in a fluid under an applied electric field. When an electric field E is applied across a piece of material, the electrons respond by moving with an average velocity called the drift velocity, .
Show more
Related publications (54)

Nanostructure and Optical Property Tailoring of Zinc Tin Nitride Thin Films through Phenomenological Decoupling: A Pathway to Enhanced Control

Aïcha Hessler-Wyser, Johann Michler, Amit Sharma, Caroline Hain, Daniele Casari, Thomas Nelis

This work addresses the need for precise control of thin film sputtering processes to enable thin film material tailoring on the example of zinc tin nitride (ZTN) thin films deposited via microwave plasma-assisted high power reactive magnetron sputtering ( ...
Amer Chemical Soc2024

Competition between Carrier Injection and Structural Distortions in Electron-Doped Perovskite Nickelate Thin Films

Duncan Thomas Lindsay Alexander, Bernat Mundet, Jonathan Spring, Jean-Marc Triscone

The discovery of superconductivity in doped infinite-layer nickelate thin films has brought increased attention to the behavior of the doped perovskite phase. Despite this interest, the majority of existing studies pertain to hole-doped perovskite rare-ear ...
WILEY2023

Electron spectrometer calibration method

Tobias Kippenberg, Fabrizio Carbone, Alexey Sapozhnik, Yujia Yang, Thomas La Grange, Arslan Sajid Raja

The present invention concerns an energy dispersion calibration method for calibrating an electron spectrometer of an electron spectrometer system including at least one electron emission source, electron optics and the electron spectrometer. The method co ...
2023
Show more
Related MOOCs (17)
Transmission Electron Microscopy for Materials Sciences
Learn about the fundamentals of transmission electron microscopy in materials sciences: you will be able to understand papers where TEM has been used and have the necessary theoretical basis for takin
Transmission Electron Microscopy for Materials Sciences
Learn about the fundamentals of transmission electron microscopy in materials sciences: you will be able to understand papers where TEM has been used and have the necessary theoretical basis for takin
Synchrotrons and X-Ray Free Electron Lasers (part 1)
Synchrotrons and X-Ray Free Electron Lasers (part 1)
Show more

Graph Chatbot

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.