Comportement du ballast sous l'action du bourrage et du trafic ferroviaire

The geometry of the railway track is degraded under traffic load, and must be maintained periodically. This degradation is due to the arrangement of ballast particles under loads and vibrations, which results into irreversible plastic settlements. Tamping is a procedure of maintenance, used to restore the correct geometrical position of the ballasted tracks. However, the penetration of the vibrating tines into the ballast causes an increase in the fine particles content by rupture of the edges of the grains and leads to a progressive degradation of the ballast and thus to a loss of its mechanical properties. The main consequence is that the interval between two tamping operations decreases, along with the long-term effectiveness of the process. This vicious circle can be broken only by ballast renewal. Ballast and geometry maintenance represent 40 to 50% of the total railway maintenance budget during lifetime. The goal of this research is a better understanding of ballast degradation and the development of a tool to evaluate the effectiveness of the track tamping, according to the ballast condition and the infrastructure stiffness. This knowledge will make it possible to decrease the destroying effects of tamping over ballast and, consequently, increase the durability of track geometry and ballast. A full-scale laboratory study has been done on ballasts and infrastructures of different qualities. The dynamic loading of freight trains is simulated with a big hydraulic actuator, while the deformations of the track and his infrastructure are continuously measured. The accelerated loading corresponds to a period of 20 years of traffic operation on a high loaded line. Empirical settlement laws are written, based on the traffic results. Tamping process is performed with a special machine, which was built by purpose. The parameters to regulate tamping process can be controlled. The whole process and the equipment are completely instrumented, in order to control and measure several parameters in real time. The evolution of the ballast behaviour is analysed with the measurement of the bearing modulus. Plate load tests are performed under specially equipped sleepers, after each traffic cycle and tamping. The parameters of a new tamping are tested. The short and long-term effects on ballast are analysed and discussed. A two-dimensional finite element model has been applied to simulate the response of the ballast layer under traffic loading, and the development of settlements. Ballast at different degradation levels is studied. The influence of the subgrade stiffness is also taken in account. The elastoplastic Hujeux behaviour law is applied, in order to study the cyclic plasticity. Results are presented and the critical zones, which show the most plastic behaviour, are identified. A phenomenological model is also developed to analyse separately the effects of traffic loading and track tamping on ballast behaviour and degradation. This analysis is based on a