Publication
Due to the significant shear forces developing around columns and the potential brittle failure associated, the punching capacity of flat slabs is the main concern at ultimate limit state. An effective way to understand the behaviour of slab-column connections has typically been by testing isolated specimens in the laboratory. While there exist many slab-column connection types in actual slabs, most research efforts have focused on the punching resistance at internal columns. Specifically, edge connections appear largely underrepresented in the literature when the number of existing tests is compared to their importance in typical building floor configu-rations. Furthermore, the favourable effect of slab continuity is generally neglected in this type of tests. This paper presents the results of an experimental campaign on two edge slab-column connections: one had no shear reinforcement, while the other had a large amount of shear reinforcement to evaluate maximum punching. A novel test setup was conceived to apply representative boundary conditions of actual continuous slabs, intro-ducing moment continuity perpendicularly to the slab free edge. Refined measurement techniques were exten-sively used, monitoring the visible slab faces using Digital Image Correlation, and instrumenting the flexural and shear reinforcement with distributed fibre-optic sensors. The failure of the slab-column connection without shear reinforcement was triggered in the region of shear stress concentrations and propagated around the column thereafter. Well-anchored vertical legs of flexural reinforcement at the free face induced a smeared-like shear crack pattern. In the shear-reinforced slab-column connection, an initial crushing of the concrete at the column front corners was followed by the formation of a local yield line along the slab axis. In addition to the enhancement of the resistance and rotation capacity, the shear studs also served for increasing the moment redistribution capacity of the system. The experimental results are compared to different codes of practice, showing that improvements are needed to better assess the resistance of edge columns.