Concept
The zero page or base page is the block of memory at the very beginning of a computer's address space; that is, the page whose starting address is zero. The size of a page depends on the context, and the significance of zero page memory versus higher addressed memory is highly dependent on machine architecture. For example, the Motorola 6800 and MOS Technology 6502 processor families treat the first 256 bytes of memory specially, whereas many other processors do not. Unlike more modern hardware, in the 1970s computer RAM was as fast as or faster than the CPU. Thus it made sense to have few registers and use the main memory as an extended pool of extra registers. In machines with a relatively wide 16-bit address bus and comparatively narrow 8-bit data bus, accessing zero page locations could be faster than accessing other locations. Zero page addressing now has mostly historical significance, since the developments in integrated circuit technology have made adding more registers to a CPU less expensive and CPU operations much faster than RAM accesses. The actual size of the zero page in bytes is determined by the microprocessor design and in older designs, is often equal to the largest value that can be referenced by the processor's indexing registers. For example, the aforementioned 8-bit processors have 8-bit index registers and a page size of 256 bytes. Therefore, their zero page extends from address 0 to address 255. In early computers, including the PDP-8, the zero page had a special fast addressing mode, which facilitated its use for temporary storage of data and compensated for the relative shortage of CPU registers. The PDP-8 had only one register, so zero page addressing was essential. In the original PDP-10 KA-10 models, the registers it has are simply the first 16 words, 36-bits long, of main memory. Those locations can be accessed as both registers and memory locations. Unlike more modern hardware, 1970s computer RAM was as fast as or faster than the CPU.