Publications associées à Flottation

Zinc carboxylate optimization strategy for extending Al-air battery system's lifetime

Andreas Züttel, Thi Ha My Pham, Liping Zhong, Manhui Wei

Although Al-air batteries are expected to be the candidates for energy conversion systems in renewable energy market due to the higher energy density, richer reserves, and lighter mass of Al metal, the anode self-discharge is seen as a notorious issue that ...

ELSEVIER SCI LTD2023

Tuning Napththalenediimide Cations for Incorporation into Ruddlesden–Popper-Type Hybrid Perovskites

Jacques-Edouard Moser, Kevin Sivula, Jun Ho Yum, Liang Yao, Etienne Christophe Socie, Simon Nussbaum

Layered hybrid organic−inorganic perovskite (LHOIP) materials constructed with low-band-gap chromophore-based organic spacer cations are anemerging class of materials that promise unique tunability of their optoelectronic properties. However, the large siz ...

2022

Some Results of the EU Project FASTGRID

Manuel Bauer

The EU FASTGRID project aimed at improving the REBCO conductor in order to enhance its economical attractiveness for the Superconducting Fault Current Limiter (SFCL). Two approaches were simultaneously investigated: i) the reduction of the tape length thro ...

IEEE Institute of Electrical and Electronics Engineers2022

Structural description of surfaces and interfaces in biominerals by DNP SENS

David Lyndon Emsley, David Benjamin Roger Antoine Gajan

Biological mineralized tissues are hybrid materials with complex hierarchical architecture composed of biominerals often embedded in an organic matrix. The atomic-scale comprehension of surfaces and organo-mineral interfaces of these biominerals is of para ...

ACADEMIC PRESS INC ELSEVIER SCIENCE2019

An alternative model for the formation of hydrous Mg/Ni layer silicates ("deweylite"/"garnierite") in faulted peridotites of New Caledonia: II. Petrography and chemistry of white and green clay infillings

Gabrielle Dublet

This study, which complements a first mineralogical work, presents detailed petrographic and chemical data on the sequences of clay infillings commonly found in serpentine veins of reactivated faults from the New Caledonian peridotite formation. Chemical t ...

E SCHWEIZERBARTSCHE VERLAGSBUCHHANDLUNG2019

Discovery and Evaluation of Biosynthetic Pathways for the Production of Five Methyl Ethyl Ketone Precursors

Vassily Hatzimanikatis, Milenko Tokic, Ljubisa Miskovic, Meriç Ataman, Noushin Hadadi

The limited supply of fossil fuels and the establishment of new environmental policies shifted research in industry and academia towards sustainable production of the 2nd generation of biofuels, with Methyl Ethyl Ketone (MEK) being one promising fuel candi ...

2018

Catalytic supercritical water gasification: Interaction of sulfur with ZnO and the ruthenium catalyst

Christian Ludwig, Frédéric Vogel, Gaël Peng

Continuous catalytic supercritical water gasification (CSCWG; 400 degrees C, 28 MPa) of microalgal biomass (Chlorella vulgaris) was carried out at the microalgae production site of ZHAW in Wadenswil (Switzerland) non-stop over a period of 100 h. Characteri ...

Elsevier2017

Catalytic Supercritical Water Gasification: Continuous Methanization of Chlorella vulgaris

Christian Ludwig, Frédéric Vogel, Gaël Peng, Dominik Refardt

Continuous catalytic supercritical water gasification (CSCWG; 400 degrees C, 28 MPa) of microalgal biomass (Chlorella vulgaris) was carried out at the microalgae production site of ZHAW in Wadenswil (Switzerland) nonstop over a period of 100 h. Microalgae ...

American Chemical Society2017

A dimerization interface mediated by functionally critical residues creates interfacial disulfide bonds and copper sites in CueP

Matteo Dal Peraro, Luciano Andres Abriata

CueP confers bacterial copper resistance in the periplasm, particularly under anaerobic conditions, through an unknown mechanism. The only available structure and limited solution data suggest that CueP forms noncovalent timers in solution, whereas sequenc ...

Elsevier Science Inc2014

Method for recovering silicon from sawing waste

Patrik Willi Hoffmann

A method for separating and recovering silicon debris from sawing waste is characterized in that it comprises the following steps: - treating the sawing waste so as to deoxidize the silicon debris in a manner that reduces their surface energy, - applying t ...

2009