Link layerIn computer networking, the link layer is the lowest layer in the Internet protocol suite, the networking architecture of the Internet. The link layer is the group of methods and communications protocols confined to the link that a host is physically connected to. The link is the physical and logical network component used to interconnect hosts or nodes in the network and a link protocol is a suite of methods and standards that operate only between adjacent network nodes of a network segment.
Network addressA network address is an identifier for a node or host on a telecommunications network. Network addresses are designed to be unique identifiers across the network, although some networks allow for local, private addresses, or locally administered addresses that may not be unique. Special network addresses are allocated as broadcast or multicast addresses. These too are not unique. In some cases, network hosts may have more than one network address. For example, each network interface controller may be uniquely identified.
Subnetwork Access ProtocolThe Subnetwork Access Protocol (SNAP) is a mechanism for multiplexing, on networks using IEEE 802.2 LLC, more protocols than can be distinguished by the 8-bit 802.2 Service Access Point (SAP) fields. SNAP supports identifying protocols by EtherType field values; it also supports vendor-private protocol identifier spaces. It is used with IEEE 802.3, IEEE 802.4, IEEE 802.5, IEEE 802.11 and other IEEE 802 physical network layers, as well as with non-IEEE 802 physical network layers such as FDDI that use 802.
Ifconfigifconfig est une commande Unix qui permet de configurer et d'afficher les informations des interfaces réseau IP à partir de l'interpréteur de commandes. Le nom ifconfig vient de l'anglais interface configurator. ifconfig est apparu en tant que composant de la suite TCP/IP de 4.2BSD. Cette commande a donc été intégrée à la boîte à outils originale d'Internet. On utilise généralement ifconfig pour configurer l'adresse IP et le masque de sous-réseau d'un ordinateur, pour afficher des informations sur les interfaces réseau, et pour activer ou désactiver une interface réseau.
Multilayer switchA multilayer switch (MLS) is a computer networking device that switches on OSI layer 2 like an ordinary network switch and provides extra functions on higher OSI layers. The MLS was invented by engineers at Digital Equipment Corporation. Switching technologies are crucial to network design, as they allow traffic to be sent only where it is needed in most cases, using fast, hardware-based methods. Switching uses different kinds of network switches. A standard switch is known as a layer 2 switch and is commonly found in nearly any LAN.
Promiscuous modePromiscuous mode (traduit de temps en temps en « mode promiscuité »), en informatique, se réfère à une configuration de la carte réseau, qui permet à celle-ci d'accepter tous les paquets qu'elle reçoit, même si ceux-ci ne lui sont pas adressés. Ce mode est une fonctionnalité généralement utilisée pour écouter le trafic réseau. Chaque paquet réseau envoyé inclut l'adresse (adresse MAC) de la carte réseau destinataire.
MAC spoofingMAC spoofing is a technique for changing a factory-assigned Media Access Control (MAC) address of a network interface on a networked device. The MAC address that is hard-coded on a network interface controller (NIC) cannot be changed. However, many drivers allow the MAC address to be changed. Additionally, there are tools which can make an operating system believe that the NIC has the MAC address of a user's choosing. The process of masking a MAC address is known as MAC spoofing.
DecnetDECnet est une architecture réseau en couches, sur un protocole défini par Digital Equipment Corporation. Les plus malicieux disent "Do Expect Cuts" (attendez-vous à des coupures). DECnet est aussi un groupe de produits de communications de données comportant une suite de protocoles développée et soutenue par Digital Equipment Corporation (Digital). La première version de DECnet, 1975, a permis à deux mini-ordinateurs PDP-11 de communiquer conjointement.
Filtrage par adresse MACEn sécurité informatique, le filtrage par adresse MAC est une méthode de contrôle d'accès au réseau informatique, basée sur l'adresse MAC physique de la carte connectée au réseau. Une adresse MAC physique est une adresse unique, assignée à chaque carte réseau, commutateur (switch), routeur, caméra IP, etc. Ainsi, utiliser le filtrage par adresse MAC sur un réseau informatique permet de contrôler l'accès au réseau d'équipements définis dans une liste blanche, une liste noire, un script, la configuration d'un pare-feu.
Universally unique identifierUniversally unique identifier (UUID), de l'anglais signifiant littéralement « identifiant unique universel », est en informatique un système permettant à des systèmes distribués d'identifier de façon unique une information sans coordination centrale importante. Dans ce contexte, le mot « unique » doit être pris au sens de « unicité très probable » plutôt que « garantie d'unicité ». Il s'agit d'une spécification DCE définie initialement par l'OSF (Open Software Foundation).