Radiation resistance is that part of an antenna's feedpoint electrical resistance caused by the emission of radio waves from the antenna. In radio transmission, a radio transmitter is connected to an antenna. The transmitter generates a radio frequency alternating current which is applied to the antenna, and the antenna radiates the energy in the alternating current as radio waves. Because the antenna is absorbing the energy it is radiating from the transmitter, the antenna's input terminals present a resistance to the current from the transmitter.
Radiation resistance is an effective resistance, due to the power carried away from the antenna as radio waves. Unlike conventional resistance or "Ohmic resistance", radiation resistance is not due to the opposition to current (resistivity) of the imperfect conducting materials the antenna is made of.
The radiation resistance () is conventionally defined as the value of electrical resistance that would dissipate the same amount of power as heat, as is dissipated by the radio waves emitted from the antenna. From Joule's law, it is equal to the total power radiated as radio waves by the antenna, divided by the square of the current into the antenna terminals:
The feedpoint and radiation resistances are determined by the geometry of the antenna, the operating frequency, and the antenna location (particularly with respect to the ground). The relation between the feedpoint resistance () and the radiation resistance () depends on the position on the antenna at which the feedline is attached.
The relation between feedpoint resistance and radiation resistance is particularly simple when the feedpoint is placed (as usual) at the antenna's minimum possible voltage / maximum possible current point; in that case, the total feedpoint resistance at the antenna's terminals is equal to the sum of the radiation resistance plus the loss resistance due to "Ohmic" losses in the antenna and the nearby soil:
When the antenna is fed at some other point, the formula requires a correction factor discussed below.
Cette page est générée automatiquement et peut contenir des informations qui ne sont pas correctes, complètes, à jour ou pertinentes par rapport à votre recherche. Il en va de même pour toutes les autres pages de ce site. Veillez à vérifier les informations auprès des sources officielles de l'EPFL.
Les antennes sont utilisées dans une multitude d'applications de communications et de détection, demandant des fréquences et propriétés d'antennes très différentes. Ce cours décrit la théorie de base
This lecture is oriented towards the study of audio engineering, with a special focus on room acoustics applications. The learning outcomes will be the techniques for microphones and loudspeaker desig
Ce cours a pour objectif de former les étudiants de section Génie Electrique et Electronique à la conception de systèmes acoustiques, à l'aide d'un formalisme basé sur l'électrotechnique. A la fin du
L'antenne dipolaire, élaborée par Heinrich Rudolph Hertz vers 1886, est une antenne constituée de deux brins métalliques, alimentée en son milieu et destinée à transmettre ou recevoir de l'énergie électromagnétique. Ce type d'antenne est le plus simple à étudier d'un point de vue analytique. 220px|thumb|Antenne dipolaire. thumb|300px|Une antenne dipolaire recevant une onde radio. thumb|Schéma géométrique d'un dipôle élémentaire.
Radiation resistance is that part of an antenna's feedpoint electrical resistance caused by the emission of radio waves from the antenna. In radio transmission, a radio transmitter is connected to an antenna. The transmitter generates a radio frequency alternating current which is applied to the antenna, and the antenna radiates the energy in the alternating current as radio waves. Because the antenna is absorbing the energy it is radiating from the transmitter, the antenna's input terminals present a resistance to the current from the transmitter.
A loading coil or load coil is an inductor that is inserted into an electronic circuit to increase its inductance. The term originated in the 19th century for inductors used to prevent signal distortion in long-distance telegraph transmission cables. The term is also used for inductors in radio antennas, or between the antenna and its feedline, to make an electrically short antenna resonant at its operating frequency. The concept of loading coils was discovered by Oliver Heaviside in studying the problem of slow signalling speed of the first transatlantic telegraph cable in the 1860s.