Publications associées à Forced-air

Embedded Microchannel Cooling for Monolithically-integrated GaN Half-bridge ICs

Elison de Nazareth Matioli, Remco Franciscus Peter van Erp, Luca Nela, Palliyage Srilak Nirmana Perera

Efficient and compact power conversion is a key requirement to achieve sustainable electrification of our society. GaN-based power devices offer major benefits compared to their silicon counterparts in terms of efficiency and integration but suffer from se ...

IEEE2021

Field evaluation of thermal and acoustical comfort in eight North-American buildings using embedded radiant systems

Caroline Karmann

We performed a post-occupancy assessment based on 500 occupant surveys in eight buildings using embedded radiant heating and cooling systems. This study follows-up on a quantitative assessment of 60 office buildings that found radiant and all-air buildings ...

2021

Heat source and voiding signatures of Mullins damage in filled EPDM

Nicolas Candau, Oguzhan Oguz

The thermomechanical coupling of Mullins damage in filled EPDM has been investigated by analysing the self-heating via Infrared thermography (IR) and the voiding fraction by Digital Image Correlation (DIC). The volumetric strain measured during the rubber ...

ELSEVIER SCI LTD2020

System for co2 capture from internal combustion engine

François Maréchal, Shivom Sharma

System (2) for CO2 capture from a combustion engine (1) comprising an exhaust gas flow circuit (6) having an inlet end fluidly connected to an exhaust of the combustion engine, a heat exchanger circuit (12), a primary exhaust gas heat exchanger (H1) for tr ...

2020

Effect of fuel isotope mass on q-profile formation in JET hybrid plasmas

Matteo Fontana

The initial current ramp phase of JET hybrid plasmas is used to optimise the target q-profile for main heating to allow access to high beta and avoid MHD instabilities. Mixed protium-deuterium experiments, carried out at JET since the installation of the b ...

IOP Publishing Ltd2020

Oxygen diffusion through air–water free surfaces in a pump–turbine operating in condenser mode

François Avellan, Elena Vagnoni, Loïc Andolfatto, Pierre Leroy

The present research aims at understanding the mass transfer of air into water in a reversible pump turbine operating in condenser mode. In particular, the diffusion of oxygen through the water free-surface both in the vaneless gap between the impeller bla ...

2019

Towards a digital workflow to assess visual impact of solar modules and their operation within energy-hubs

Jean-Louis Scartezzini, Silvia Coccolo, Amarasinghage Tharindu Dasun Perera, Pietro Florio

This study proposes an integrated methodology to assess the BIPV potential of existing urban neighborhoods, including social acceptance and grid infrastructure management issues; as a demonstration, a case study in Geneva, Switzerland is considered. In par ...

IOP Science2019

Nearing final design of the ITER EC H&CD Upper Launcher

Olivier Sauter, Timothy Goodman, René Chavan, Jean-Daniel Landis, Robert Bertizzolo, Matteo Vagnoni, Florian Ramseyer, Emanuele Poli

The ITER ECRH system consists of 24 gyrotrons with up to 24 MW installed millimeter wave heating power at 170 GHz, power supplies, control system, transmission lines, one Equatorial and the four Upper Launchers. With its high frequency and small beam focus ...

ELSEVIER SCIENCE SA2019

Development and optimisation of advanced auxiliary ion heating schemes for 3D fusion plasma devices

Hamish William Patten

The magnetic confinement fusion devices known as the tokamak and the stellarator are progressing towards becoming viable commercial nuclear fusion reactor designs. Both ap- proaches require improvements in the applied heating sources and in the particle an ...

EPFL2019

The Evolution of the Pompidou Centre's Air Conditioning System. Toward a new figure of architecture

Boris Hamzeian

The integration of technical services in architecture played a crucial role in the history of post-war construction. The Centre Pompidou, conceived and realized between 1971 and 1977 by the architecture studio Piano and Rogers and the engineering firm Ove ...

Construction History Society2018