Publications associées à Injection (moteur)

Addressing the challenges of homogeneity, quality control and waste handling in soil bio-cementation: A large-scale experiment

Lyesse Laloui, Dimitrios Terzis, Ray Harran

In an attempt to go beyond the conventional laboratory experiments widely reported in literature around the emerging technique of soil bio-cementation, this work addresses key challenges related to its large-scale application. Precisely, a state-of-the-art ...

JAPANESE GEOTECHNICAL SOC2023

Intentional oxygen oscillations on Pd/Al2O3 for enhanced methane removal from the exhaust of natural gas engines

Maneka Claire Roger

Natural gas (NG) is a suitable alternative to gasoline and diesel fuels to decrease the carbon footprint of the mobility and energy sectors. Although NG is considered a fossil fuel, methane (CH4), its main component, can be produced industrially from power ...

EPFL2022

Experimental characterization of a solid oxide fuel cell coupled to a steam-driven micro anode off-gas recirculation fan

Jan Van Herle, Jürg Alexander Schiffmann, Stefan Diethelm, Zacharie Wuillemin, Patrick Hubert Wagner, David Constantin

While the global fuel utilization of solid oxide fuel cells (SOFCs) is limited by the stack aging rate, the fuel excess is typically used in a burner, and thus limiting the system electrical efficiency. Further, natural-gas-fueled SOFCs require treated wat ...

2020

Simulation of thermal stresses in anode-supported solid oxide fuel cell stacks. Part II: Loss of gas-tightness, electrical contact and thermal buckling

Daniel Favrat, Jan Van Herle, Arata Nakajo, Zacharie Wuillemin

Structural stability issues in planar solid oxide fuel cells arise from the mismatch between the coefficients of thermal expansion of the components. The stress state at operating temperature is the superposition of several contributions, which differ depe ...

2009

Development and application of an advanced fuel model for the safety analysis of the generation IV gas-cooled fast reactor

Petr Petkevich

Until about the year 2030, current-day nuclear power plants (NPPs) will be replaced by so-called Gen-III or Gen-III+ units, which are mainly based on light water reactor technology. The principal new features are increased safety and improved economical ef ...

EPFL2008