Multipath propagationIn radio communication, multipath is the propagation phenomenon that results in radio signals reaching the receiving antenna by two or more paths. Causes of multipath include atmospheric ducting, ionospheric reflection and refraction, and reflection from water bodies and terrestrial objects such as mountains and buildings. When the same signal is received over more than one path, it can create interference and phase shifting of the signal. Destructive interference causes fading; this may cause a radio signal to become too weak in certain areas to be received adequately.
Wireless Internet service providerA wireless Internet service provider (WISP) is an Internet service provider with a network based on wireless networking. Technology may include commonplace Wi-Fi wireless mesh networking, or proprietary equipment designed to operate over open 900 MHz, 2.4 GHz, 4.9, 5, 24, and 60 GHz bands or licensed frequencies in the UHF band (including the MMDS frequency band), LMDS, and other bands from 6 GHz to 80 GHz. In the US, the Federal Communications Commission (FCC) released Report and Order, FCC 05-56 in 2005 that revised the FCC’s rules to open the 3650 MHz band for terrestrial wireless broadband operations.
National broadband planBroadband is a term normally considered to be synonymous with a high-speed connection to the internet. Suitability for certain applications, or technically a certain quality of service, is often assumed. For instance, low round trip delay (or "latency" in milliseconds) would normally be assumed to be well under 150ms and suitable for Voice over IP, online gaming, financial trading especially arbitrage, virtual private networks and other latency-sensitive applications. This would rule out satellite Internet as inherently high-latency.
Broadband over power linesBroadband over power lines (BPL) is a method of power-line communication (PLC) that allows relatively high-speed digital data transmission over the public electric power distribution wiring. BPL uses higher frequencies, a wider frequency range and different technologies compared to other forms of power-line communications to provide high-rate communication over longer distances. BPL uses frequencies that are part of the radio spectrum allocated to over-the-air communication services; therefore, the prevention of interference to, and from, these services is a very important factor in designing BPL systems.
Broadband Integrated Services Digital NetworkIn the 1980s, the telecommunications industry expected that digital services would follow much the same pattern as voice services did on the public switched telephone network, and conceived an end-to-end circuit switched service, known as Broadband Integrated Services Digital Network (B-ISDN). Before B-ISDN, the original ISDN attempted to substitute the analog telephone system with a digital system which was appropriate for both voice and non-voice traffic.
Matrice de contrôleUne matrice de contrôle est un concept de théorie des codes utilisé dans le cas des codes correcteurs linéaires. Elle correspond à la matrice d'une application linéaire ayant pour noyau le code. La notion de matrice de contrôle possède à la fois un intérêt théorique dans le cadre de l'étude des codes correcteurs, par exemple pour offrir des critères sur la distance minimale du code ou une condition nécessaire et suffisante pour qu'un code soit parfait et un intérêt pratique pour un décodage efficace.
IEEE 802.20IEEE 802.20 or Mobile Broadband Wireless Access (MBWA) was a specification by the standard association of the Institute of Electrical and Electronics Engineers (IEEE) for mobile broadband networks. The main standard was published in 2008. MBWA is no longer being actively developed. This wireless broadband technology is also known and promoted as iBurst (or HC-SDMA, High Capacity Spatial Division Multiple Access). It was originally developed by ArrayComm and optimizes the use of its bandwidth with the help of smart antennas.
Nomenclature codesNomenclature codes or codes of nomenclature are the various rulebooks that govern biological taxonomic nomenclature, each in their own broad field of organisms. To an end-user who only deals with names of species, with some awareness that species are assignable to families, it may not be noticeable that there is more than one code, but beyond this basic level these are rather different in the way they work. The successful introduction of two-part names for species by Linnaeus was the start for an ever-expanding system of nomenclature.
Déclaration avancéeEn programmation informatique, une déclaration avancée est une déclaration d'un identificateur représentant une entité (par exemple un type, une variable, une fonction) pour laquelle la définition n'est fournie qu'ultérieurement dans le code.
