Fine sediment dynamics in unsteady open-channel flow studied with acoustic and optical systems

In order to simulate fine sediment dynamics over an armored bed in a tidal river, unsteady accelerating, then steady open-channel flow over a movable (but not moving) coarse gravel bed (D-50=5.5 mm) was studied. A layer of fine sediment (D-50=120 mu m) was placed on the coarse gravel bed. The thickness of the fine sediment layer on the gravel bed was varied between 4 and 6 mm, but it was found that the thickness of the layer had no effect on the results. Quasi-instantaneous profiles of velocity and sediment concentration were taken simultaneously and co-located. An Acoustic Doppler Velocity Profiler (ADVP) was combined with Particle Tracking Velocimetry (PTV) for suspended sediment particle tracking. Measurements resolved turbulence scales. During the final phase of the accelerating flow range, fine sediment suspension from the bed started in packets and rapidly created a ripple pattern that remained nearly stationary. Thereafter, vortex shedding produced most of the sediment suspension into the water column in the form of events or packets, making suspension intermittent. Simultaneously, sediment particles rolled along the bed following the ripple structure, thus slowly advancing the ripple pattern in the direction of the flow without altering ripple geometry. Fine sediment particles and hydrogen bubbles were used individually or combined as flow tracers in the acoustic measurements. When used individually, hydrogen bubbles provided full depth flow and backscattering information, whereas sediment particles traced only the lower layers of the flow, indicating sediment suspension. When both tracers were combined, hydrogen bubbles could only be distinguished from sediment particles when results at two different acoustic carrier frequencies were compared. The intermittency was observed in the backscattering of the acoustic system. The event structure in fine sediment suspension is seen by the PTV method. PTV velocity vectors varied in speed and orientation, were organized in large coherent packets, mainly in the near bed layers, but also extended well above the bed. The two methods provide complementary information. ADVP measurements allow long time series analysis, whereas most of the spatial details seen in the PTV results cannot be resolved in the ADVP measurements. (c) 2012 Elsevier Ltd. All rights reserved.

Sediment Suspension Dynamics in Turbulent Unsteady, Depth-Varying Open-Channel Flow over a Gravel Bed

Fereshteh Bagherimiyab Hunkeler

Even though flow in natural rivers and channels is generally unsteady, only a few studies on turbulent structures in unsteady open-channel flows have been carried out. In hydraulic engineering problems, unsteady flow is often approximated with concepts of steady flow, because the treatment of unsteady flow can be difficult. Many variables enter into the mathematical relationship and the differential equations cannot be integrated in closed form, except under very simplified conditions. The limited number of studies of unsteady flow may also be due to the lack of experimental equipment capable of capturing small-scale, unsteady open-channel flow dynamics. Therefore, it is important to know when unsteady flow can be approximated by steady flow concepts and which simplifications are acceptable. In most cases, especially when simulating unsteady flood flow by a steady flow approach, the calculations may not produce reliable results. The mechanism of sediment transport in rivers and open channels is governed by complicated interactions between unsteady accelerating and decelerating turbulent flow, particle motion and bed configuration. Understanding the dynamics of unsteady sediment-laden water flows and characterizing the velocity of suspended particles is essential for enhancing the predictive accuracy of sediment transport and its impact on environmental processes in the water column. In order to simulate fine sediment dynamics over an armored bed in a river during the passage of a flood wave, unsteady accelerating, and decelerating open-channel flow over a movable (but not moving) coarse gravel bed (D50 = 5.5 mm) first without and then with fine sediment were studied. A layer of fine sediment of mean particle size about 120 µm was placed on the coarse gravel bed. The thickness of the fine sediment layer on the gravel bed was varied between 4 mm and 6 mm, but it was found that the thickness of the layer had no effect on the results. Quasi-instantaneous profiles of velocity and sediment concentration were taken simultaneously and co-located. An acoustic Doppler and imaging method, using an Acoustic Doppler Velocity Profiler (ADVP) was combined with an optical method, using Particle Tracking Velocimetry (PTV) for suspended sediment particle tracking. Measurements resolved turbulence scales. Unsteadiness strongly affects the profile shape of velocity and friction velocity, particularly in the final phase of the accelerating range. Flow in the decelerating range approaches steady flow. Systematically higher friction velocities were observed in the accelerating flow than in the decelerating flow for comparable flow depth. This indicates that for the same change of relative submergence, different flow dynamics are generated during accelerating and decelerating flows. For the lowest unsteadiness (90 s hydrograph), the differences between velocity profiles in the accelerating and the decelerating ranges become small, indicating that for this unsteadiness, steady state conditions are approached. During the accelerating flow range, fine sediment suspension from the bed started in bursts and in the final phase of the accelerating flow range, a ripple pattern is rapidly created that remained nearly stationary. Thereafter, vortex shedding produced most of the sediment suspension into the water column in the form of events, making suspension intermittent. Simultaneously, sediment particles rolled along the bed following the ripple structure, thus slowly advancing the ripple pattern in the direction of the flow. However, ripple geometry and ripple shape were not altered by this process, despite the fact that flow velocities changed. Due to the ripple structure, high sediment suspension events continued to occur in bursts during the decelerating flow even though mean flow velocity and friction velocity decreased. The dynamics of sediment suspension observed in this study indicate that mean value concepts cannot be applied in unsteady flow. Fine sediment particles and hydrogen bubbles were used individually and combined as flow tracers in the acoustic measurements. When used individually, hydrogen bubbles provided full depth flow and backscattering information, whereas sediment particles traced only the lower layers of the flow, indicating sediment suspension. When both tracers were combined, hydrogen bubbles could not be distinguished from sediment particles. The intermittency was observed in the backscattering of the acoustic system. The event structure in fine sediment suspension is seen by the PTV method. PTV velocity vectors varied in speed and orientation, but were organized in large coherent packets, mainly in the near-bed layers. They also extended well above the bed, supporting the concept that coherent structure events contribute to sediment suspension over ripples. The two methods provide complementary information. ADVP measurements allow long timeseries analysis, whereas the spatial details seen in the PTV results cannot be resolved in the ADVP measurements.

EPFL2012

Experimental study of suspension flow in open channels

The study of the sediment transport in open-channel as well as in river flow is of great importance for fluvial hydraulics. While the transport of sedimentary particles at the bed, as the bed-load, has been the subject of much research, less attention has been paid to the transport of sediments in suspension. This thesis is a contribution to our knowledge of the transport of sediments in suspension. The most important theory on the vertical distribution of the mean sediment concentration in suspension flows is the diffusion-convection theory, given by the Rouse equation. This equation is rather simple and contains few parameters. About one of these parameters, the β-value, there is little known, despite its importance and physical meaning. One of the main aims of this thesis is to experimentally measure the β-values for different suspension flow configurations. The major objective was to investigate suspension flows over moveable beds without bed forms and this in capacity condition. Since flows are at times not in capacity, i.e. the flows are not saturated with sediments, an additional study (see Appendix C) was also performed. Furthermore, two special runs were done (see Appendix D), where the bed was covered with artificial bed forms. In order to evaluate the β-values, the vertical profiles of the mean velocity and its fluctuations as well as the mean concentration and its fluctuations had to be measured. This could only be done by using the new ultrasonic instrument (Acoustic Particle Flux Profiler, APFP), developed and assembled at the Laboratoire de Recherches Hydrauliques (LRH). Suspension flows were investigated focusing on the possible modification of the clear-water turbulence by suspended sediments. The concentration was carefully measured and interpreted by the Rouse equation. In particular, the ratio of the sediment, εs(y) , and momentum, εm(y) , diffusion coefficients, being the β(y) -value, was for the first time, directly measured. The strongest effect of particles on the flow was noticed on the vertical component of the turbulence intensity, , which was considerably suppressed, when compared to clear-water flow. The longitudinal velocity, u(y) , its turbulence intensity component, , and the Reynolds stress, – ρu'v' , were only slightly affected. By using the APFP instrument, the instantaneous sediment concentrations, cs, were, for the first time, directly measured. The calibration of the APFP instrument was achieved by measuring the mean concentration profiles, cs, with the suction method. The largest measured fluctuating concentrations, , and sediment flux, profiles were observed close to the bed, where the mean concentration is also very large. The sediment, εs, and the momentum, εm, diffusion coefficients, which represent the "ability" of sediment and fluid particles to be diffused in the flow by turbulence, were computed from the APFP measurements. For suspension flows over plane-bed, the sediment diffusion-coefficient profiles are always smaller than the momentum ones, εs < εm. This indicates that sediment particles undergo less diffusion than fluid particles; consequently the β-values are less than unity, β < 1. Thus, the usual assumption of εs = εm, that leads to β = 1, is not justified for the present measurements. The Rouse equation gives a better agreement to the concentration distributions measured with the suction method, by using the experimental obtained β-values, , rather than by using β = 1. For practical use, the experimental values and the ones obtained by a best-fit (least-squares method) of the Rouse equation to some concentration distributions taken from the literature are summarized in a plot. It seems that the β-values increase with either scaling parameters, vss/u*, and (vss/u*) · (Cs/csa). The effects of suspended particles on the clear-water turbulence were also investigated in non-capacity suspension flows having increasing concentrations. The measurements show that, the suppression (damping) of the vertical component of the turbulence intensity – caused by suspended particles – increases with the depth-averaged concentration. The tendency of the - values to decrease approaching the capacity condition, i.e. increasing the concentration, was also found. Suspension flows over bed forms were also investigated; in this study special attention was paid to the evolution of the flow structure behind the bed-form crest as well as the effect of bed forms on the β-values. The bed-form crest seems to generate a high-turbulence region with consequent peaks in both the longitudinal and vertical turbulence-intensity profiles as well as in the Reynolds-stress profiles. This high-turbulence region enhances the sediment diffusion coefficient but suppresses the momentum one. As a consequence, we found that for suspension flows over beds with bed forms, εs > εm, leading to β > 1. The most important result of this thesis is a recommendation that the Rouse equation with an improved β-value – itself to be estimated from the experimental plots obtained in this study – can be used to establish the dimensionless concentration profile of suspension flows. For beds without bed forms the β-values are β < l, while for beds with bed forms the β-values are β > 1. The correlation between the velocity fluctuations, associated with coherent structures (burst cycle), and the concentration was also investigated. From this study it becomes evident that the ejection event, being the most important phase of a burst cycle, is responsible of the erosion of sediment on the bed, behaving as an "injector" of sediments into the main flow.

EPFL1998

Shear velocity estimates in rough-bed open-channel flow

Fereshteh Bagherimiyab Hunkeler, Ulrich Lemmin

Shear velocity u() is an important parameter in geophysical flows, in particular with respect to sediment transport dynamics. In this study, we investigate the feasibility of applying five standard methods [the logarithmic mean velocity profile, the Reynolds stress profile, the turbulent kinetic energy (TKE) profile, the wall similarity and spectral methods] that were initially developed to estimate shear velocity in smooth bed flow to turbulent flow over a loose bed of coarse gravel (D-50=15cm) under sub-threshold conditions. The analysis is based on quasi-instantaneous three-dimensional (3D) full depth velocity profiles with high spatial and temporal resolution that were measured with an Acoustic Doppler Velocity Profiler (ADVP) in an open channel. The results of the analysis confirm the importance of detailed velocity profile measurements for the determination of shear velocity in rough-bed flows. Results from all methods fall into a range of +/- 20% variability and no systematic trend between methods was observed. Local and temporal variation in the loose bed roughness may contribute to the variability of the logarithmic profile method results. Estimates obtained from the TKE and Reynolds stress methods reasonably agree. Most results from the wall similarity method are within 10% of those obtained by the TKE and Reynolds stress methods. The spectral method was difficult to use since the spectral energy of the vertical velocity component strongly increased with distance from the bed in the inner layer. This made the choice of the reference level problematic. Mean shear stress for all experiments follows a quadratic relationship with the mean velocity in the flow. The wall similarity method appears to be a promising tool for estimating shear velocity under rough-bed flow conditions and in field studies where other methods may be difficult to apply. This method allows for the determination of u() from a single point measurement at one level in the intermediate range (03

Wiley-Blackwell2013