Instrument intercomparison in the pulsed neutron fields at the CERN HiRadMat facility

An intercomparison of the performances of active neutron detectors was carried out in pulsed neutron fields in the new HiRadMat facility at CERN. Five detectors were employed: four of them (two ionization chambers and two rem counters) are routinely employed in the CERN radiation monitoring system, while the fifth is a novel instrument, called LUPIN, specifically conceived for applications in pulsed neutron fields. The measurements were performed in the stray field generated by a proton beam of very short duration with momentum of 440 GeV/c impinging on a dump. The beam intensity was steadily increased during the experiment by more than three orders of magnitude, with an H*(10) due to neutrons at the detector reference positions varying between a few nSv per burst and a few µSv per burst. The aim of the experiment was to evaluate the linearity of the detector response in extreme pulsed conditions as a function of the neutron burst intensity. The results show that the ionization chambers have a quasi-linear response, very close to the ideal behaviour also for values of H*(10) of a few µSv/burst; the LUPIN response shows a slight deviation from the ideal curve when the H*(10) per burst is higher than 100 nSv; the rem counters response are characterized by a strong deviation from the linearity for H*(10) values higher than a few ten of nSv.

Instrument intercomparison in the pulsed neutron fieldsat the CERN HiRadMat facility

Nikolaos Charitonidis, Daniel Perrin

An intercomparison of the performances of active neutron detectors was carried out in pulsed neutron fields in the new HiRadMat facility at CERN. Five detectors were employed: four of them (two ionization chambers and two rem counters) are routinely employed in the CERN radiation monitoring system, while the fifth is a novel instrument, called LUPIN, specifically conceived for applications in pulsed neutron fields. The measurements were performed in the stray field generated by a proton beam of very short duration with momentum of 440 GeV/c impinging on a dump. The beam intensity was steadily increased during the experiment by more than three orders of magnitude, with an H*(10) due to neutrons at the detector reference positions varying between a few nSv per burst and a few mu Sv per burst, whereas the gamma contribution to the total H*(10) was negligible. The aim of the experiment was to evaluate the linearity of the detector response in extreme pulsed conditions as a function of the neutron burst intensity. The results show that the ionization chambers have a quasi-linear response, very close to the ideal behaviour also for values of H*(10) of a few mu Sv/burst; the LUPIN response shows a slight deviation from the ideal curve when the H*(10) per burst is higher than 100 nSv; the rem counters response are characterized by a strong deviation from the linearity for H*(10) values higher than a few tens of nSv. (C) 2013 Elsevier Ltd. All rights reserved.

Pergamon-Elsevier Science Ltd2014

Radiation protection studies for CERN Linac4/SPL accelerator complex

Egidio Mauro

CERN is presently designing a new chain of accelerators to replace the present Proton Synchrotron (PS) complex: a 160 MeV room-temperature H- linac (Linac4) to replace the present 50 MeV proton linac injector, a 3.5 GeV Superconducting Proton Linac (SPL) to replace the 1.4 GeV PS booster (PSB) and a 50 GeV synchrotron (named PS2) to replace the 26 GeV PS. Linac4 has been funded and the civil engineering work started in October 2008, whilst the SPL is in an advanced stage of design. Beyond injecting into the future 50 GeV PS, the ultimate goal of the SPL is to generate a 4 MW beam for the production of intense neutrino beams. The radiation protection design is driven by the latter requirement. This thesis summarizes the radiation protection studies conducted for Linac4. FLUKA Monte Carlo simulations, complemented by analytical estimates, were performed 1) to evaluate the propagation of neutrons through the waveguide, ventilation and cable ducts placed along the accelerator, 2) to estimate the radiological impact of the accelerator in its low energy section, where the access area is located, and 3) to calculate the induced radioactivity in the air and in the components of the accelerator. The latter study is particularly important for maintenance interventions and final disposal of radioactive waste. Two possible layouts for the CCDTL section of the machine were considered in order to evaluate the feasibility, from the radiological standpoint, of replacing electromagnetic quadrupoles with permanent magnet quadrupoles with high content of cobalt. The present work provides complete information on beam loss assumptions, accelerator structure and duct and maze design, in order to make the present results of sufficiently general interest and provide guidelines for similar studies for intermediate energy proton accelerators. In addition to the Linac4-specific studies, this thesis also discusses FLUKA simulations performed to test the capability of the code, in a proton therapy application, in predicting induced radioactivity from intermediate energy protons. The thesis also reviews the analytical models mostly used for the calculation of neutron streaming through penetration traversing shielding barriers, discusses the FLUKA simulations performed to test the reliability of these models and, on the basis of the simulations, derives a universal expression that can be used to estimate the neutron transmission through a straight duct in direct view of the source, model missing so far in the literature.

EPFL2009

Characterization of Extended Range Bonner Sphere Spctrometers in the CERF high-energy broad neutron field at CERN

Nikolaos Charitonidis, Angelo Esposito, Marco Silari

The accurate determination of the ambient dose equivalent in the mixed neutron-photon fields encountered around high-energy particle accelerators still represents a challenging task. The main complexity arises from the extreme variability of the neutron energy, which spans over ten orders of magnitude or more. Operational survey instruments, which response function attempts to mimic the fluence-to-ambient dose equivalent conversion coefficient up to GeV neutrons, are available on the market, but their response is not fully reliable over the entire energy range. Extended range rem counters (ERRC) do not require the exact knowledge of the energy distribution of the neutron field and the calibration can be done with a source spectrum. If the actual neutron field has an energy distribution different from the calibration spectrum, the measurement is affected by an added uncertainty related to the partial overlap of the fluence-to- ambient dose equivalent conversion curve and the response function. For this reason their operational use should always be preceded by an “in-field” calibration, i.e. a calibration made against a reference instrument exposed in the same field where the survey-meter will be employed. In practice the extended-range Bonner Sphere Spectrometer (ERBSS) is the only device which can serve as reference instrument in these fields, because of its wide energy range and the possibility to assess the neutron fluence and the ambient dose equivalent (H⁎(10)) values with the appropriate accuracy. Nevertheless, the experience gained by a number of experimental groups suggests that mandatory conditions for obtaining accurate results in workplaces are: (1) the use of a well-established response matrix, thus implying validation campaigns in reference monochromatic neutrons fields, (2) the expert and critical use of suitable unfolding codes, and (3) the performance test of the whole system (experimental set-up, elaboration and unfolding procedures) in a well controlled workplace field. The CERF (CERN-EU high-energy reference field) facility is a unique example of such a field, where a number of experimental campaigns and Monte Carlo simulations have been performed over the past years. With the aim of performing this kind of workplace performance test, four different ERBSS with different degrees of validation, operated by three groups (CERN, INFN-LNF and Politecnico of Milano), were exposed in two fixed positions at CERF. By using different unfolding codes (MAXED, GRAVEL, FRUIT and FRUIT SGM), the experimental data were analyzed to provide the neutron spectra and the related dosimetric quantities. The results allow assessing the overall performance of each ERBSS and of the unfolding codes, as well as comparing the performance of three ERRCs when used in a neutron field with energy distribution different from the calibration spectrum.