Demo: Efficient Delay and Apodization for on-FPGA 3D Ultrasound

In medical diagnosis, ultrasound (US) imaging is one of the most common, safe, and powerful techniques. Volumetric (3D) US is potentially very attractive, compared to 2D US, because it might enable telesonography - decoupling the local image acquisition, by an untrained person, and the diagnosis, by the trained sonographer, who can be remote. Unfortunately, current 3D systems are hospital-oriented, bulky and expensive, and they cannot be available in emergency operations or rural areas. This motivates us to develop a portable US platform with cheap, battery-operated, more efficient electronics.

Single-FPGA 3D Ultrasound Beamformer

Federico Angiolini, Marcel Arditi, Giovanni De Micheli, Aya Mohamed Naguib Ahmed Ibrahim, Jean-Philippe Thiran, Ahmet Caner Yüzügüler

In medical diagnosis, ultrasound (US) imaging is one of the most common, safe, and powerful techniques. Volumetric (3D) US imaging, an emerging technique, is even more attractive than standard 2D imaging, as it allows for imaging without the local presence of a trained sonographer finely positioning the probe. This would be particularly useful in rescue operations, remote areas and developing countries. Unfortunately, present-day 3D imagers are expensive, bulky and power-hungry, confining them to hospitals. There is therefore a strong motivation to develop efficient electronics to enable a portable US platform that is small, cheap, and battery- operated. Beamforming (BF) is the most computationally expensive of 3D imaging. Both commercial [1] and research [2] imagers have dealt with the challenge by reducing the number of receive channels, hence simplifying the computation through the usage of far fewer elements. This comes at the cost of image quality, and the resulting machines are nonetheless still non-portable and expensive. In turn, the bottleneck of the BF process is the calculation of acoustic delays, which requires up to trillions of square roots per second. We propose a drastically more efficient architecture [3]. With geometric considerations, each delay is calculated from a small set of square roots (mapped onto CORDICs), plus two additions. In this demo, we will show the reconstruction of a 2.5M-voxel volume, supporting a transducer with 32×32 receive channels. We have fitted the architecture into a single Kintex UltraScale KU040 [4], which is unprecedented. We also extrapolated the utilization of a 80×80 instance on a Virtex UltraScale XCVU190 [4]. Table I shows the implementation results. Fig. 1 shows our beamformer custom block connected to the other FPGA subsystems. The delay calculation architecture is shown in Fig. 2. The demo setup is presented in Fig. 3, where the 3D beamformer is implemented on the FPGA, while the pre- and post-processing stages are currently performed on Matlab.

Ieee2016

Single-FPGA 3D Ultrasound Beamformer

Federico Angiolini, Marcel Arditi, Giovanni De Micheli, Aya Mohamed Naguib Ahmed Ibrahim, Jean-Philippe Thiran, Ahmet Caner Yüzügüler

Ieee2016