Effect of dislocations, Al-3(Sc,Zr) distribution and ageing temperature on theta ' precipitation in Al-Cu-(Sc)-(Zr) alloys
Publications associées (38)
Graph Chatbot
Chattez avec Graph Search
Posez n’importe quelle question sur les cours, conférences, exercices, recherches, actualités, etc. de l’EPFL ou essayez les exemples de questions ci-dessous.
AVERTISSEMENT : Le chatbot Graph n'est pas programmé pour fournir des réponses explicites ou catégoriques à vos questions. Il transforme plutôt vos questions en demandes API qui sont distribuées aux différents services informatiques officiellement administrés par l'EPFL. Son but est uniquement de collecter et de recommander des références pertinentes à des contenus que vous pouvez explorer pour vous aider à répondre à vos questions.
The mechanical behaviour of metallic materials that have a microstructure composed of a brittle phase embedded in a ductile matrix is dictated by a complex interplay of factors such as local phase properties, cohesive properties, geometrical characteristic ...
Variations of Vickers hardness were observed in Al-Mg-Mn alloy and Al-Mg-Mn-Sc-Zr alloy at different ageing times, ranging from a peak value of 81.2 HV at 54 ks down to 67.4 HV at 360 ks, below the initial hardness value, 71.8 HV at 0 ks for the case of Al ...
A microscopic three-point bending test that measures the strength of faceted particles of high aspect ratio is developed and used to probe individual coarsened plate-like silicon particles extracted from the eutectic Al-12.6%Si alloy. Focused ion beam mill ...
Microstructural characterization of Inconel 718 superalloy after three different heat treatment variants was performed by electron microscopy and electron tomography techniques, taking advantage of recent development in quantitative electron microscopy. Di ...
W-2Y, W-1Y(2)O(3) and W-2Y(2)O(3) materials have been fabricated using two different powder metallurgy methods. While W-2Y and W-1Y(2)O(3) have been fabricated using mechanical alloying and hot isostatic pressing (Hipping), W-2Y(2)O(3) has been fabricated ...
Precipitation hardening remains an important and efficient way to improve the mechanical resistance of aluminium alloys. In the case of the Al-Mg-Si system (6XXX series), a complex precipitation sequence occurs, which is greatly affected by the presence of ...
2013
, , ,
In this paper, a simple but realistic approach is presented to predict the as-quenched residual stress distribution in thick 7xxx aluminium alloy plates. Instead of modelling precipitation that occurs during quenching, a thermo-mechanical model is used who ...
Elsevier2015
The friction stress resulting from alloying elements in industrial alloys is an important strengthening mechanism. Since the preparation of single crystal from industrial material is difficult, no direct measurement of this quantity has been reported in li ...
In this work a combination of advanced transmission electron microscopy and spectroscopy techniques enabled a statistically significant analysis of various types of few nanometer size oxides particles in Fe-14Cr-2W-O.3Ti-0.3Y(2)O(3) ferritic steel. These m ...
Background: Focused electron beam induced deposition (FEBID) is a direct-writing technique with nanometer resolution, which has received strongly increasing attention within the last decade. In FEBID a precursor previously adsorbed on a substrate surface i ...