Posez n’importe quelle question sur les cours, conférences, exercices, recherches, actualités, etc. de l’EPFL ou essayez les exemples de questions ci-dessous.
AVERTISSEMENT : Le chatbot Graph n'est pas programmé pour fournir des réponses explicites ou catégoriques à vos questions. Il transforme plutôt vos questions en demandes API qui sont distribuées aux différents services informatiques officiellement administrés par l'EPFL. Son but est uniquement de collecter et de recommander des références pertinentes à des contenus que vous pouvez explorer pour vous aider à répondre à vos questions.
This thesis is focused on the properties of microcellular aluminium, produced by replication processing, at the micro, meso and macrostructural level. The replication process is based on the infiltration of a porous sodium chloride (NaCl) perform with molt ...
Twinned dendrite growth has been found to occur in aluminum alloys when critical thermal conditions (G approximate to 100 K/cm, nu(s) approximate to 1 mm/s) and a slight convection in the melt are present during directional solidification. Split in their t ...
Minerals, Metals & Materials Soc, 184 Thorn Hill Rd, Warrendale, Pa 15086-7514 Usa2009
TiAl is a well known high temperature material with good creep properties. It is investigated as a potential structural material for Generation IV high temperature gas cooled nuclear reactors. The tests are performed with the ABB-2 (Ti-rich TiAl with 2 at. ...
In the quest of materials for the first wall of the future fusion reactor, it has been shown that oxide dispersion strengthened (ODS) ferritic / martensitic (F/M) steels appear to be promising candidates. The inherent good mechanical properties supported b ...
Tensile tests have been performed on replicated aluminum alloy foams of relative density between 4.5% and 8%. During the test the electrical resistance was measured with a four-point set-up and the displacements along the gage section were measured using a ...
During cold forming processes materials are subjected to non-monotonic complex multiaxial loadings. To obtain complex shapes at low temperature requires the use of particularly ductile materials. The damage behaviour of two ductile steels is studied here a ...
A fairly simple experimental setup has been designed for testing the resistance of the mushy zone of alloys during solidification under tensile conditions. It has been used to study the effect of coalescence among the solid grains at a late stage of solidi ...
The tensile mechanical response of three semi-solid as-cast aluminum alloys - AA3104, AA6111, and CA31218 (an alloy similar in composition to AA3003) - was measured between a fraction solid f(s) similar to 0.85 and f(s) similar to 1 in order to establish t ...
Two types of oxide dispersion strengthened (ODS) ferritic steels, with the composition of Fe-14Cr-2W-0.3Ti-0.3Y(2)O(3) (in weight percent), have been produced by mechanically alloying elemental powders of Fe, Cr, W, and Ti with Y2O3 particles either in arg ...
