Publication
Cataract is the leading cause of blindness worldwide. The clouding of the human eye lens is called "Grauer Star" in German. In the industrialized countries this process of increased blindness is corrected by the surgical removal of the clouded lens and its replacement by a plastic lens (intraocular lens, IOL). Cataract surgery is the most frequent surgery worldwide. In Europe more than two million operations are performed annually. For the selection of an optimum replacement the refractive power of the lens is calculated from the radius of curvature of the cornea, the length of the eye and the anterior chamber depth. Therefore these data have to be measured before every surgery. Until now the length of the eye was measured exclusively by ultrasound in the clinical praxis. For this procedure the sound transducer has to be placed directly or via a water funnel onto the cornea. It was the aim of the work presented in this thesis to lay the framework for introducing into the clinical praxis a contact free optical length measurement of the eye. The basic parameters for the measurement were determined. Starting from the state of the art new solutions were found, implemented in a laboratory device, and tested clinically. A two-beam interferometer with light of short coherence length that had been developed at the University Vienna was analyzed and compared with the one-beam technique. Neglecting practical limitations due to the optical arrangement and assuming shot-noise limited detection the one-beam technique allows the measurement of reflected light that is a factor of two lower compared to the two-beam technique. From the point of view of detection both techniques are therefore equivalent. The advantage of the two-beam technique is its independence from the eye movement. Until now the two-beam technique utilizes for detection only 1 over 400 of the light reflected from the retina and 1 over 2500 to 1 over 4000 of the light reflected from the cornea. This causes the dynamic range to drop by 26 dB. Furthermore the noise of the electronics (excess noise) comes into play. In this work a novel concept for the optical configuration in the two-beam interferometer is presented. By using a diffractive lens cornea and retina are imaged simultaneously onto the detector and the losses of the light from the retina are minimized. The cornea is imaged with an efficiency of 5.6 per cent. In order to minimize the requirements on the patient the measuring time was shortened to 1 s. Therefore the scan speed was increased by a factor of four compared to the state of the art. In the laboratory device it fluctuated by 20 per cent. To keep the detection narrow band it was necessary to implement a signal processing that is largely independent of the scan speed. By using a synchronous demodulation of two 90 degrees phase-shifted channels that are added as vector quantities a filter with self-adjusting center frequency was created. Its bandwidth is 4 kHz with signal frequenc
Frédéric Courbin, Cameron Alexander Campbell Lemon