On detection of the Fermi edge in in situ grown thin films of high-T-c oxides

Mike Abrecht, Giorgio Margaritondo, Davor Pavuna
2001
Article

Résumé

We discuss our systematic series of experiments on the photoelectric detection of the Fermi edge using a cylindrical mirror analyser on films of high-T-c oxides. grown in situ by pulsed laser ablation. The Fermi edge (comparable to the edge of the reference Ag) is very easily observed even in the two-phase BSCCO-2212 film that exhibits onsets of superconducting transitions, at 85 and 45 K. In contrast, the Fermi edge is weaker and more difficult to observe even in the state-of-the-art. highly epitaxial, monophase YBa2Cu3O7-y (YBCO) and NdBa2Cu3O7-y. (NBCO-123) films (both with T-c = 92 K). So far we could not detect the Fermi edge in the films of the double-'chain' YBCO-124. (C) 2001 Elsevier Science B.V. All rights reserved.

Official source

https://infoscience.epfl.ch/record/90392?ln=fr

À propos de ce résultat

Cette page est générée automatiquement et peut contenir des informations qui ne sont pas correctes, complètes, à jour ou pertinentes par rapport à votre recherche. Il en va de même pour toutes les autres pages de ce site. Veillez à vérifier les informations auprès des sources officielles de l'EPFL.

Concepts associés

Chargement

Publications associées

Chargement

Phase diagram and electronic properties of high-T-c superconducting oxides

Davor Pavuna

We firstly briefly summarize some of the most relevant recent results and open questions across rather complex electronic phase diagram of cuprates. We continue with a discussion of results on thin superconducting oxide films grown by laser ablation. Systematic studies show that BSCCO-phases and LSCO-214 exhibit conductor-like Fermi edge, whereas materials containing "chains" (like YBCO-123) are prone to very rapid surface degradation, most likely related to critical oxygen loss at the outermost layers. Recently, direct ARPES dispersion measurements on in-situ grown, strained 10UC thin LSCO-214 films (T-C = 44 K) have shown the band crossing of Fermi level well before the Brillouin zone boundary. This is in contrast to the flat band observed in unstrained single crystals - and to the band flattening predicted by band calculations for in-plane compressive strain. In spite of density of states reduction near the Fermi level, the critical temperature increases in strained films with respect to unstrained crystals; this poses further challenge to HTSC theory

2003

Chargement

Irradiation-induced disorder in high-T-c cuprates: electronic band structure study

Marco Grioni, Giorgio Margaritondo

We used thermal neutron irradiation to produce disorder in Bi-2212 single crystals (T-c = 85 K), at a constant carrier density. The irradiated samples were insulators. High-temperature superconductivity with a lower T-c than prior to irradiation could be restored by a low-temperature annealing. We performed angle-resolved photoemission investigation on both unannealed (insulating) and annealed (superconducting) samples in order to study the corresponding changes in electronic structure. We observed a strong suppression of the spectral weight near the Fermi energy with increasing disorder. Our results demonstrate that effects related to disorder cannot be neglected in the interpretation of the spectral properties of cuprates. (C) 1998 Elsevier Science B.V. All rights reserved.

1998

Chargement

, , ,

We use a pulsed laser deposition (PLD) setup to grow ultra-thin films of high temperature superconductors (HTSC) and transfer them in-situ into a photoemission chamber. Photoemission measurements on such films allow us to study noncleavable materials, but can also give insights into aspects never measured before, like the influence of strain on the low energy electronic structure. Systematic studies of many different materials grown as films showed that Bi2Sr2CaCu2O8+x, Bi2Sr2Cu1O6+x, Bi2Sr2Ca2Cu3O10+x, and La2-xSrxCuO4 films exhibit a conductor-like Fermi edge, but materials containing chains (such as YBa2Cu3O7-x) are prone to very rapid surface degradation, possibly related to critical oxygen loss at the surface. Among HTSC materials, La2-xSrxCuO4 is extremely interesting because of its rather simple structure and the fact that its critical temperature T, can be enhanced by epitaxial strain. Here we present our first high resolution angular resolved photoemission spectroscopy (ARPES) results on 8 unit-cell thin La2-xSrxCuO4 films on SrLaAlO4 [001] substrates. Due to the lattice mismatch, such films are compressed in the copper oxygen planes and expanded in the c-axis direction. Results show a surprisingly modified Fermi surface compared to the one of non-strained samples.

Spie-Int Society Optical Engineering2002

Chargement