A data link is a means of connecting one location to another for the purpose of transmitting and receiving digital information (data communication). It can also refer to a set of electronics assemblies, consisting of a transmitter and a receiver (two pieces of data terminal equipment) and the interconnecting data telecommunication circuit. These are governed by a link protocol enabling digital data to be transferred from a data source to a data sink.
There are at least three types of basic data-link configurations that can be conceived of and used:
Simplex communications, most commonly meaning all communications in one direction only.
Half-duplex communications, meaning communications in both directions, but not both ways simultaneously.
Duplex communications, communications in both directions simultaneously.
In civil aviation, a data-link system (known as Controller Pilot Data Link Communications) is used to send information between aircraft and air traffic controllers for example when an aircraft is too far from the ATC to make voice radio communication and radar observations possible. Such systems are used for aircraft crossing the Atlantic and Pacific oceans. One such system, used by Nav Canada and NATS over the North Atlantic, uses a five-digit data link sequence number confirmed between air traffic control and the pilots of the aircraft before the aircraft proceeds to cross the ocean. This system uses the aircraft's flight management computer to send location, speed and altitude information about the aircraft to the ATC. ATC can then send messages to the aircraft regarding any necessary change of course.
In unmanned aircraft, land vehicles, boats, and spacecraft, a two-way (full-duplex or half-duplex) data-link is used to send control signals, and to receive telemetry.
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Data communication or digital communications, including data transmission and data reception, is the transfer and reception of data in the form of a digital bitstream or a digitized analog signal transmitted over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires, optical fibers, wireless communication using radio spectrum, storage media and computer buses. The data are represented as an electromagnetic signal, such as an electrical voltage, radiowave, microwave, or infrared signal.
A computer network is a set of computers sharing resources located on or provided by network nodes. Computers use common communication protocols over digital interconnections to communicate with each other. These interconnections are made up of telecommunication network technologies based on physically wired, optical, and wireless radio-frequency methods that may be arranged in a variety of network topologies. The nodes of a computer network can include personal computers, servers, networking hardware, or other specialized or general-purpose hosts.
Radar is a radiolocation system that uses radio waves to determine the distance (ranging), angle (azimuth), and radial velocity of objects relative to the site. It is used to detect and track aircraft, ships, spacecraft, guided missiles, and motor vehicles, and map weather formations, and terrain. A radar system consists of a transmitter producing electromagnetic waves in the radio or microwaves domain, a transmitting antenna, a receiving antenna (often the same antenna is used for transmitting and receiving) and a receiver and processor to determine properties of the objects.
Within this paper an industry-driven insight to an environmental development project will be given. The approach offers the novel possibility to interconnect commercially available sensors to economic and high-performance floating platforms. Each platform ...
Paul Scherrer Institute, World Resources Forum2019
Implanted medical devices (IMDs) have been widely developed to support the monitoring and recording of biological data inside the body or brain. Wirelessly powered IMDs, a subset of implantable electronics, have been proposed to eliminate the limitations r ...
This article demonstrates person localization using a hybrid system consisting of an electromagnetic positioning system and a depth camera to authorize access control. The ultimate aim of this system is to distinguish moving people in a defined area by tra ...