Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.
DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.
Over the past decades, an increasing number of bridges with integral abutment have been built in Switzerland. This type of bridge offers various advantages over standard bridges with abutments, equipped with expansion joints and bearings that require regul ...
The weakness of nickel-based solid oxide fuel cell anodes is their low ability to withstand re-oxidation at working temperature, especially for the anode-supported cell design. The volume expansion coming along with nickel (Ni) oxidation induces stresses i ...
We report on the use of grazing-incidence time-resolved x-ray diffraction to investigate the evolution of strain in natural graphite excited by femtosecond-laser pulses in the fluence range of 6-35 mJ/cm(2). Strains corresponding to up to similar to 2.8% c ...
The new turbulence generator consists of a standard uniform grid with tethered spheres attached to its nodes and is capable of producing approximately twice the turbulence energy per unit pressure drop coefficient C (p) than the same bare grid without the ...
Thermally-induced residual stresses, generated during the industrial Direct Chill casting process of aluminum alloys, can cause both significant safety concerns as well as the formation of defects during down-stream processing. Although these thermally ind ...
Detailed neutron powder diffraction (NPD) expts. were carried out on the parent and CO2 adsorbed Mg-MOF-74 (MOF: metal-org. framework). Data collected at low temp. revealed two CO2 adsorption sites on the pore surface and multiple changes in the framework ...
The effect of the temperature dependence of the internal friction angle is studied in a boundary value problem simulating the impact of a cylindrical heat source on the soil mass in which it is embedded. This follows a previous study which shows that such ...
The effect of temperature on the crack onset strain (COS) of brittle coatings on polymer substrates was investigated through a series of temperature-controlled tensile tests carried out in situ under an optical microscope. It was observed that the failure ...
Velocity fields in rectangular shallow reservoirs with different length-to-width and expansion ratios were investigated in an experimental study, to evaluate the effect of geometry on the flow field. A wide range of combinations of these two non-dimensiona ...
Variability of the internal friction angle with temperature is studied in a boundary value problem numerically simulating the impact of a cylindrical heat source on the stress and strain in soil mass in which it is emplaced. Even if the thermal increase of ...
International Center for Computational Engineering (IC2E)2011
