Are you an EPFL student looking for a semester project?
Work with us on data science and visualisation projects, and deploy your project as an app on top of Graph Search.
Concept
Fluid bearing
Summary
Fluid bearings are bearings in which the load is supported by a thin layer of rapidly moving pressurized liquid or gas between the bearing surfaces. Since there is no contact between the moving parts, there is no sliding friction, allowing fluid bearings to have lower friction, wear and vibration than many other types of bearings. Thus, it is possible for some fluid bearings to have near-zero wear if operated correctly.
They can be broadly classified into two types: fluid dynamic bearings (also known as hydrodynamic bearings) and hydrostatic bearings. Hydrostatic bearings are externally pressurized fluid bearings, where the fluid is usually oil, water or air, and is pressurized by a pump. Hydrodynamic bearings rely on the high speed of the journal (the part of the shaft resting on the fluid) to pressurize the fluid in a wedge between the faces. Fluid bearings are frequently used in high load, high speed or high precision applications where ordinary ball bearings would have shortened life or caused high noise and vibration. They are also used increasingly to reduce cost. For example, hard disk drive motor fluid bearings are both quieter and cheaper than the ball bearings they replace. Applications are very versatile and may even be used in complex geometries such as leadscrews.
The fluid bearing may have been invented by French civil engineer L. D. Girard, who in 1852 proposed a system of railway propulsion incorporating water-fed hydraulic bearings.
Fluid bearings are noncontact bearings that use a thin layer of rapidly moving pressurized liquid or gas fluid between the moving bearing faces, typically sealed around or under the rotating shaft. The moving parts do not come into contact, so there is no sliding friction; the load force is supported solely by the pressure of the moving fluid. There are two principal ways of getting the fluid into the bearing:
In fluid static, hydrostatic and many gas or air bearings, the fluid is pumped in through an orifice or through a porous material.
Official source
About this result
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.