Hydroelectric power in India

Summary

India is 5th globally for installed hydroelectric power capacity. As of 31 March 2020, India's installed utility-scale hydroelectric capacity was 46,000 MW, or 12.3% of its total utility power generation capacity. Additional smaller hydroelectric power units with a total capacity of 4,683 MW (1.3% of its total utility power generation capacity) have been installed. India's hydroelectric power potential is estimated at 148,700 MW at 60% load factor. In the fiscal year 2019–20, the total hydroelectric power generated in India was 156 TWh (excluding small hydro) with an average capacity factor of 38.71%. The hydroelectric power plants at Darjeeling and Shivanasamudra were established in 1898 and 1902, respectively. They were among the first in Asia and India has been a dominant player in global hydroelectric power development. India also imports surplus hydroelectric power from Bhutan. Small hydropower, defined to be generated at facilities with nameplate capacities up to 25 MW, comes

Official source

https://en.wikipedia.org/wiki/Hydroelectric_power_in_India

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Related publications (5)

Related publications

Related people

Related units

Related concepts (3)

Related concepts

Related courses (4)

La conception générale et l'agencement des différentes infrastructures et batteries hydroélectriques, avec le dimensionnement de leurs ouvrages hydrauliques principaux.

This course covers the fundamental and applied aspects of electrocatalysis related to renewable energy conversion and storage. The focus is on catalysis for hydrogen evolution, oxygen evolution, and CO2 reduction reactions. Both homogeneous and heterogeneous catalysts are discussed.

Les barrages font partie des plus grands ouvrages réalisés par l'humanité. Ce cours donne une introduction au domaine fascinant de la conception et de la construction des barrages, indispensables pour l'approvisionnement en eau et en énergie mais intégrés à l'environnement, partout dans le monde.

Related courses

Related lectures (11)

Related lectures

Improving frequency containment reserve provision in run-of-river hydropower plants

Francesco Gerini, Mario Paolone, Elena Vagnoni

The paper presents a model-based control strategy for optimal asset management of hydroelectric units in run-of-river hydropower plants. The proposed control strategy aims to operate the unit at the best efficiency while improving water flow management and minimise components wear during frequency containment reserve provision. This approach is designed for a double regulated turbine (Kaplan) with adjustable guide vanes angle and runner blades angle and can be extended to other turbines adopted in run-of-river hydropower plants. The optimal discharge set-point is computed for maximising the frequency containment reserve provision while controlling the head of the river. The best efficiency is achieved by solving a suitably defined convex optimisation problem leveraging a regressive model of the hydraulic characteristics of the turbine and dynamics of the guide vanes and blades servomotors. The discharge set-point combines three terms: the dispatch plan set-point, the regulating discharge, proportional to the grid frequency deviation, and an offset term computed to control the average flow through the machine. Furthermore, a method to forecast the energy required in the following hour for the provision of grid frequency regulation is exploited to enhance the unit’s frequency containment reserve action. The control strategy is validated by simulating a month of operation for the full-scale run-of-river hydropower plant located in Vogelgrun (France) and by comparing the results with operational statistics. Results show the effectiveness of the proposed control strategy able to increase the provision of frequency containment reserve while decreasing the number of movements of the machine components and maximise the efficiency.

2021

Dynamic behaviour of a Francis turbine during voltage regulation in the electrical power system

François Avellan, Elena Vagnoni

Hydroelectric units can be operated in synchronous condenser mode to provide reactive power to the electrical power system (EPS) for voltage regulation. In this operating mode, the hydraulic turbine consumes active power and in case of hydroelectric units equipped with a Francis turbine, pressurized air is injected in the draft tube to decrease the tailwater level below the runner for decreasing the friction losses. Several dynamic phenomena have been recorded during full-scale hydraulic turbine operation due to the air–water mixing causing pressure and torque fluctuations which may compromise the operation and safety of both the hydraulic machine and the EPS. In this paper, the study of the dynamic response of a Francis turbine prototype during synchronous condenser mode operation is performed to evaluate the transposition of the machine behaviour from the homologous reduced scale model to the full-scale prototype. Measurements of the pressure in draft tube cone, machine vibrations, and torque are performed in both full scale prototype and reduced scale model. The analysis of the dynamic behaviour of the hydraulic turbine focuses on the critical vibrations and power fluctuations. The onset of a sloshing wave in the draft tube cone is highlighted as predicted by the reduced scale model tests. Rotor–stator interactions (RSI) are analyzed and compared to the RSI during generating mode operation. The advantages of decreasing the pressure in the vaneless gap between the runner blades and the closed guide vanes by installing a draining pipe are emphasized to limit the amplitude of the fluctuations and to avoid unwanted two-phase flow phenomena in the vaneless gap which can perturb the machine operation and safety.

2020

On the Hydroelectric Stability of an Islanded Power Network.

Philippe Allenbach, François Avellan, Jean-Jacques Simond

slanded power networks comprising a small number of large power plants are subject to perturbations leading to important transients, and, hence need high performance governors. The design of these governors requires a detailed model of the system. This is even more important in the case of hydroelectric power plants featuring surge tank and long penstock. For a complete understanding of the dynamic behavior of the system, the model must also take into account the interaction with the electrical power network. This paper presents such a modeling for a 1 GW hydroelectric power plant and the use of an efficient method for the governor parameter determination. Assessment of the governor performances is carried out for different power ratios between hydroelectric and whole network

2006