Concept

Plywood

Related publications (56)

Transverse cracking in the bulk and at the free edge of thin-ply composites: experiments and multiscale modelling

John Botsis, Robin Amacher, Joël Cugnoni, Sébastien Kohler

Thin-ply composites were shown to exhibit significantly delayed transverse cracking, but the linear onset of damage scaling with ply thickness reported by Amacher et al. (2014) did not correspond to the established LEFM based in situ strength model. This s ...

2019

Multiscale experimental characterisation and modelling of transverse cracking in thin-ply composites

Sébastien Kohler

In this work, the damage dependency on ply thickness is investigated experimentally for three different thin-ply CFRP quasi-isotropic laminates, with constituents spanning a large range of properties. It is shown that free edge damage mechanisms, observed ...

EPFL2019

Influence of ply-angle on fracture in antisymmetric interfaces of CFRP laminates

John Botsis, Georgios Pappas, Charlie Joseph Simon Blondeau

Laminated composites are prone to fracture at layer interfaces. Such damage impairs their structural response and engenders important constraints in design. In this work, the influence of ply orientation on crack growth resistance was studied for three dif ...

ELSEVIER SCI LTD2019

Influence of the stacking sequence on the low-energy impact resistance of flax/PA11 composite

Yann Albert Gérard Lebaupin

In this paper, the low-energy impact behavior of a fully biobased composite made of bio-sourced polyamide 11 resin reinforced with flax fibers was investigated. Different composite laminates were studied in order to determine the stacking sequence effects ...

SAGE PUBLICATIONS LTD2019

Single chamber multiple degree-of-freedom soft pneumatic actuator enabled by adjustable stiffness layers

Jamie Paik, Marco Salerno, Junius Santoso

Soft pneumatic actuators promise simple, adaptable, and safe manipulation, but the nature of pneumatic circuits limits the scalability of this approach. This paper introduces a method to augment the degrees-of-freedom of soft pneumatic actuators without in ...

2019

Towards aerospace grade thin-ply composites: Effect of ply thickness, fibre, matrix and interlayer toughening on strength and damage tolerance

John Botsis, Robin Amacher, Joël Cugnoni, Larissa Sorensen, Sébastien Kohler

Thin-ply composites represent a promising approach to further improve the performance of carbon fibre composite structures thanks to their ability to delay the onset of matrix cracking and delamination up to the point of fibre dominated failure. However, t ...

ELSEVIER SCI LTD2018

The influence of through-thickness reinforcement geometry and pattern on delamination of fiber-reinforced composites: Part I - Experimental results

Véronique Michaud, John Botsis, Georgios Pappas

This experimental study reports effect of tuft geometry i.e., standard tufts and loops milled-down, and tufting pattern on Mode I interlaminar fracture in a GFRP. Standard tufting geometry is responsible for an increase in fracture resistance by 3.5-6 time ...

Elsevier2018

Effects of load interruption on the fatigue life of GFRP composites

Thomas Keller, Anastasios Vassilopoulos, Abdolvahid Movahedirad

The effect of cyclic loading interruption on the fatigue behavior of angle-ply (±45)2S glass/epoxy composite laminates was investigated by comparing the obtained results of continuous- and interrupted loading patterns. Continuous fatigue experiments were p ...

2018

Fracture of thin-ply composites

Guillaume Frossard

The demand for carbon/epoxy laminated composites is continuously increasing due to their high specific modulus and strength. Among them, laminates made of particularly thin layers (from t=0.015 to 0.150 mm) and called thin-ply composites are gaining in int ...

EPFL2017

Integrally attached timber folded surface structures

Andrea Stitic

In structural engineering, folded surface structures present one of the concepts for construction of self supporting column free systems. They utilize structural benefits of folding to achieve material saving and improve structural efficiency. The folding ...

EPFL2017

Graph Chatbot

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.