Magnetic circular dichroism in electron microscopy

Cécile Hébert
2008
Journal paper

Abstract

Although the analogies between the electron energy loss spectra and X-ray absorption spectra were recognized long ago, the possibility to observe the magnetic circular dichroism in the electron microscope was demonstrated only recently. This technique combines the atom specificity with the high spatial resolution of the transmission electron microscope. Being a very young technique, there are still many open questions concerning the optimization of the signal to noise ratio. In this paper we study the dichroic signal dependence on the sample thickness, acceleration voltage and incoming beam tilt angle of bcc-Fe and fcc-Ni.

Official source

https://infoscience.epfl.ch/record/134156?ln=en

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Related concepts

Related publications

Magnetic circular dichroism in electron energy loss spectrometry

Cécile Hébert

The measurement of circular dichroism in the electron microscope is a new, emerging method and, as such, it is subject to constant refinement and improvement. Different ways can be envisaged to record the signal. We present an overview of the key steps in the energy-loss magnetic chiral dichroism (EMCD) experiment as well as a detailed review of the methods used in the intrinsic way where the specimen is used as a beam splitter. Lateral resolution up to 20-30 nm can be achieved, and the use of convergent beam techniques leads to an improved S / N ratio. Dichroic effects are shown for Ni and Co single crystal; as a counterexample, measurements were carried also for a non-magnetic (Ti) sample, where no dichroic effect was found.

2008

, , ,

The aim of this work was to develop a controllable route to produce a stable and inorganic layer on the surface of multi-wall carbon nanotubes. Precursor compounds such as TiBr4, TiCl4, Ti(OiPr)(4), and Ti(OEt)(4) were used to cover the surface of carbon nanotubes (CNTs) under either solvent free or solution conditions. Various titania precursors were compared in the formation of homogeneous layers on the surface of CNTs. As-prepared titania coverages were characterized by transmission electron microscopy (TEM), high resolution TEM, scanning electron microscopy, electron energy loss spectroscopy, and Xray diffraction techniques. Results revealed that homogeneous coverage can be achieved in a controllable way. (C) 2010 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim

2010

In an era of new developments in nanomaterials analysis enabled by the unprecedented spatial and energy resolutions of electron energy-loss spectroscopy in the scanning transmission electron microscope (STEM-EELS), it remains that the vast majority of works concern collective or single-particle excitations that are well described by the electrostatic approximation, which neglects retardation and magnetic field effects. Here we demonstrate a simple case in which that approximation is fundamentally inadequate. When the beam energy is above the Cherenkov threshold and the geometric dimensions of the nanomaterial sample are on the order of the wavelength of light in the material, spatial variations in low-loss (less than or similar to 5 eV) spectral maps from guided light modes may be observed. We demonstrate such observations for amorphous silicon disks and offer an interpretation of the results based on the waveguide modes of a cylinder. We also demonstrate explicitly that spatial variations from waveguide modes are manifest in analytic models for the especially simple geometry of a STEM beam penetrating a dielectric ribbon. We discuss how these modes relate to those that have been observed more generally in dielectric nanomaterials.

2021