Single crystal study of the heavy-fermion antiferromagnet CePt2In7

We report the synthesis, structure, and physical properties of single crystals of CePt2In7. Single crystal x-ray diffraction analysis confirms the tetragonal I4/mmm structure of CePt2In7 with unit cell parameters a = 4.5886(6) Å, c = 21.530(6) Å and V = 453.32(14) Å3. The magnetic susceptibility, heat capacity, Hall effect and electrical resistivity measurements are all consistent with CePt2In7 undergoing an antiferromagnetic order transition at TN = 5.5 K, which is field independent up to 9 T. Above TN, the Sommerfeld coefficient of specific heat is γ ≈ 300 mJ mol−1 K−2, which is characteristic of an enhanced effective mass of itinerant charge carriers. The electrical resistivity is typical of heavy-fermion behavior and gives a residual resistivity ρ0 ~ 0.2 µΩ cm, indicating good crystal quality. CePt2In7 also shows moderate anisotropy of the physical properties that is comparable to structurally related CeMIn5 (M = Co, Rh, Ir) heavy-fermion superconductors.

Pressure-tuned Transport Properties of Novel Iron-based Superconductors and Topological Insulators

Andrea Pisoni

The majority of interactions in solids strongly depend on the interatomic distances. The application of pressure changes the lattice parameters and modifies the electronic and the phononic energy spectra of a material avoiding some of the undesirable effects induced by chemical doping, like lattice disorder, impurity phases and phase separations. Layered materials are particularly affected by the application of pressure because their anisotropic structure eases the contraction of the lattice along specific crystallographic directions. In this thesis I study the effect of pressure on the transport properties of two new layered materials: L4Fe2As2Te(1-x)O4 (L = Pr, Sm, Gd) superconductors and beta-Bi4I4 topological insulator. The discovery of Fe-based superconductors (Fe-SCs) provided a new material base for studying the mechanism of high temperature superconductivity. These materials present unexpectedly high critical temperatures (Tc ) despite the presence of magnetic atoms. The parent compounds of Fe-SCs are semimetals with an antiferromagnetic ground state in which the itinerant electrons form a periodic modulation of spin density called spin density wave (SDW). By changing the structural properties or by adding/removing carriers the SDW order can be suppressed and superconductivity emerges. Our group recently succeeded in synthesizing a new family of Fe-SCs that presents Tc up to 45 K upon optimum chemical doping and substitution. I performed a systematic study of the upper critical field and the pressure-dependent electrical resistivity of single crystals of Pr4Fe2As2Te(1-x)O4 and Sm4Fe2As2Te(1-x)O(4-y)Fy . Hall coefficient and magnetoresistance of Pr4Fe2As2Te(1-x)O4 revealed electrons as the dominant type of charge carriers. The results can be successfully fitted by a two-band model that allows the estimation of the temperature dependent electron and hole densities and mobilities. In view of the exceptionally high structural anisotropy of this new class of Fe-SCs I investigated the electronic anisotropy of Sm4Fe2As2Te(1-x)O(4-y)Fy by means of microfabrication techniques. The results show a ratio between the out-of-plane and in-plane electrical resistivities that is the highest reported so far in Fe-SCs. Topological insulators (TIs) form another class of materials that is currently attracting a lot of attention both for fundamental physics and potential applications. In TIs metallic surface states coexist with an insulating bulk. Most of the TIs known so far are either three-dimensional strongly bonded bulk materials or layered van der Waals crystals. Beta-Bi4I4 is a material composed of quasi-one-dimensional molecular chains that was theoretically predicted, and only recently experimentally verified, to be a novel strong topological insulator. Due to its particular structure, beta-Bi4I4 offers the possibility to study the interplay between different ground states like topological insulating phase, charge-density-wave and superconductivity. Here I present, for the first time, a study of the thermoelectric properties of beta-Bi4I4 single crystals. Electrical resistivity, Seebeck coefficient, thermal conductivity and Hall coefficient measurements reveal a possible charge density-wave-order (CDW) at low temperature. According to resistivity and thermoelectric power measurements, pressure suppresses the CDW order. Resistivity measurements performed in a diamond anvil cell up to 20 GPa demonstrate that superconductivity is induced in beta-Bi4I4 for pressure above 10 GPa. Preliminary X-ray diffraction measurements by synchrotron radiation, performed on the sample recovered at ambient pressure after the experiment, reveal that a new Bi-I phase is formed at high pressure. The possibility that the topological insulator state could coexist with superconductivity in beta-Bi4I4 is certainly a fascinating option but it remains for now an open question.

EPFL2016

Synthesis, crystal growth and physical properties of the frustrated spin ladder material BiCu2PO6

Shuang Wang

In recent years quantum antiferromagnets with an intrinsically disordered (“spin liquid”) ground state and an energy gap in the spin excitation spectrum have received a great deal of attention. In search for new experimental realizations of spin-ladder and related models, we have embarked upon a new interesting family of low-dimensional materials with the general formula BiCu2AO6 (A = P, V and As). Among them, BiCu2PO6 shows a structure where Cu spins appear to form a two-leg zigzag ladder, which is believed to be a valuable model of a quantum magnet. However, for detailed studies of quantum magnetism, single crystals are indispensible. Therefore, in this thesis, synthesis and characterization of the newly-discovered spin ladder material BiCu2PO6 (BCPO) and its derivatives in the form of powder and single crystal are presented. Polycrystalline samples of Bi(Cu1-xZnx)2PO6 (x= 0.01, 0.02, 0.03, 0.04, 0.05 and 1), Bi1-y(Ca, Sr, La )yCu2PO6 (y = 0.15, 0.5 and 1) and BiCu2(P1-zVz)O6 (z = 1) were synthesized in this work. The solid state synthesis reactions, phase purity and thermal properties of the samples, substitution solubility, and preliminary magnetic susceptibility have been studied by thermal analysis (TG-DTA), X-ray powder diffraction (XRD), and Scanning Electron Microscope (SEM) as well as DC magnetization measurements, respectively. The BiCu2PO6 structure shows a remarkable chemical flexibility and interesting substitution effects. For detailed studies of the magnetic properties, well characterized large single crystals are indispensable. Thus in this thesis, a number of single crystal growth experiments have been performed using the Travelling Solvent Floating Zone method (TSFZ). Under the elaborated crystal growth conditions (growth rate of ~1 mm/h, gas mixture of 20% O2 in Argon, total 3 pressure (6~6.5 bar), high quality cm -size single crystals of Bi(Cu1-xZnx)2PO6 (x = 0, 0.01, 0.03, 0.05) have been successfully grown for the first time. For these crystals phase purity, crystal morphology/orientation, defect density, chemical composition distribution, crystal structure (room temperature and 1.5 K) and single crystal quality were thoroughly studied based on X-ray and neutron powder diffraction, optical and scanning electron microscopy, X-ray/neutron Laue diffraction, ICP-OES/X-ray fluorescence and two-axis neutron diffraction. Moreover, the specific heat Cp (H,T), AC susceptibility χ(H,T) and DC magnetization M(H,T) measurements on well-characterized single crystal samples of the undoped BCPO and 5% Zn-doped BCPO with the field applied along main crystallographic axes were performed in order to study the unique low temperature magnetic behaviour exhibited in this system, such as anisotropy of the magnetic properties, impurity-induced magnetism by the substitution of non-2+ magnetic cations (e.g. Zn ) and frustration. The magnetic phase diagram (H-T) under low field has been constructed. Further results obtained by close collaborators, based on the measurements made on single crystal samples grown in this thesis, including field-induced quantum phase transitions, NMR, Raman studies are attached directly at the end of this thesis.

EPFL2013

Thermopower as a Unique Tool to Probe Quantum Phase Transitions

Stevan Arsenijevic

In my thesis, transport measurements such as resistivity and, more importantly, thermopower S, were used to explore the phase diagram of bad metals. Bad metals are electronically correlated systems whose ground state lies close to a quantum phase transition. By tuning the control parameters, such as temperature (T ), magnetic field (B), hydrostatic pressure (p) or chemical substitution (x), we can induce phase transitions between the various electronic, magnetic and structural phases. Here, the thermopower is presented as a unique tool for probing quantum phase transition because it is a measure of the entropy of conducting electrons. The main part of the thesis is dedicated to the study of Fe-based superconductors (FeSC) discovered in 2008. Their parent compound has an antiferromagnetic (AF) ground state, where the itinerant electrons form a spin-density wave (SDW), a periodic modulation of spin density. This coincides or is preceded by a structural, tetragonal-to-orthorhombic transition. The nesting between the electron and hole Fermi surface is believed to be the driving mechanism for the SDW state. By changing the structural or chemical properties the AF ground state of FeSC is suppressed, giving way to superconductivity (SC). The remaining antiferromagnetic fluctuations above the transition can provide a glue for SC pairing. Here, the analysis of the thermopower S/T of BaFe1−xCoxAs2 (BFCA) in the x-T phase diagram shows the signatures of the spin fluctuation which have a dome-like dependence and follow the trend of superconducting Tc . The logarithmic increase of S/T upon decreasing T is ascribed to the proximity of the spin-density-wave quantum critical point. It can be understood as an increase of entropy due to the incommensurate AF spin fluctuations. We can ascribe the high values of thermopower in BFCA at intermediate- and room-temperatures to the influence of low-T quantum criticality. To probe the response of the electronic system in FeSC to structural changes, we performed measurements under pressure of the parent compound BaFe2As2 (BFA), the SC electron-doped BFCA, and hole-doped Ba1−xKxFe2As2 (BKFA). In the parent compound pressure suppresses the structural/SDW transition, similar to the effect of doping. For doped systems, in order to describe the behavior of thermopower in the high-T range (above 100K) we used a semi-metallic two-band model which was fitted to the data in order to extract the pressure dependence of the band parameters. In both doping cases the effect of pressure was similar, an increase of the band overlap and of the effective number of charge carriers. With this model we can explain the high-T , x and p dependence of thermopower in both electron- and hole-doped BFA. In a structurally simpler Fe-chalcogenide Fe1+yTe1−xSex compound, the excess of Fe has a Kondo-like influence on the charge carriers which dramatically changes the physics of the normal state. To probe the normal state, pressure, doping, magnetic Fe-excess concentration (y) and temperature were used as control parameters. At low-T a characteristic upturn of resistivity (ρmag ) is observed, followed by an increase of thermopower (Smag ), which we identify as the magnetic contribution caused by the spin-flip scattering events. Increasing the y resulted in an increase of ρmag , and a decrease of Smag , which is in agreement with the behavior of canonical Kondo-systems. Pressure suppresses the magnetic contribution to transport, thus increasing the itinerancy of the system. MnSi is another system in which the sensitivity of thermopower to entropy brings new information related to the complex magnetic structure. Pressure was used to drive the system from a helically ordered, canonical Fermi-liquid (FL) phase with T 2-resistivity to the intrinsically disordered, non-Fermi-liquid (NFL) phase above pc with T3/2-dependence. Our contour plot of S/T demonstrated how powerful the thermopower technique is, by reproducing the whole previously established T -p phase diagram. At the phase transition from the magnetically-ordered FL phase to the disordered NFL, the thermopower is dramatically enhanced. We bring useful information about the mysterious partial order (PO) phase inside the NFL phase, previously detected only by neutron scattering. The fluctuating helices scenario can describe the observed increase of entropy/thermopower in the PO phase. At ambient pressure, close to the helical transition of MnSi, a moderate magnetic field can stabilize the skyrmion lattice - the lattice of topological magnetic whirls, vortices. We observe a signature of the skyrmion lattice as a minute drop in thermopower. It is located exactly in the same region of the T − B phase diagram where an increase in magnetoresistance and Hall effect was reported previously. This feature originates from the additional scattering of conducting electrons on magnetic vortices, while the change in S is dominated by the decrease of entropy as the stable skyrmion lattice is formed. Overall, resistivity was used to confirm the established phase diagram, while thermopower, as an interesting and not sufficiently understood technique, was used to probe the sensitive changes of the charge carriers at the Fermi surface. We explored various phases showing how useful thermopower is to probe the entropy of electronic system on the verge of quantum phase transition.

EPFL2012