Publications related to Four Quadrant Bus-Tie Switch for Protection of Shipboard Power Systems

Phase Shift Angle Segmentation Modulation for Soft-Switching Medium-Voltage DAB Converter With Series-Connected SiC MOSFETs

The medium-voltage (MV) dual active bridge (DAB) converter with series-connected SiC (S-SiC) MOSFETs is a promising solution for high-power-density isolated dc/dc converter. To improve the voltage sharing and reliability of S-SiC, relatively large snubber ...

Ieee-Inst Electrical Electronics Engineers Inc2024

DC Power Distribution Networks with Direct Current Transformers

Renan Pillon Barcelos

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

Ripple Voltage and Loss Reduction of Single-Phase ISOP SST by Eliminating the Second Harmonic Current in LLC Converters

Drazen Dujic, Andrea Cervone, Tianyu Wei

In two-stage solid-state transformers with input-series output-parallel structure, the LLC converter operating at a fixed switching frequency is a common choice for the isolated DC/DC conversion stage because it can provide a high efficiency and a fixed vo ...

2024

Active Voltage Balancing with Seamless Integration into Dual Gate Driver for Series Connection of SiC MOSFETs

Drazen Dujic

The versatility of half-bridge configuration of silicon carbide (SiC) metal-oxide-semiconductor field-effect transistor (MOSFET) power module contributes to its widespread adoption, highlighting the popularity and significance of its corresponding dual gat ...

2024

An Ultralow-Power Triaxial MEMS Accelerometer With High-Voltage Biasing and Electrostatic Mismatch Compensation

Kyojin Choo, Li Xu, Yimai Peng

This article presents a triaxial micro electromechani-cal system (MEMS) capacitive accelerometer using a high-voltage biasing technique to achieve high resolution with ultralow power. The accelerometer system generates a differential pair of high voltages ...

Ieee-Inst Electrical Electronics Engineers Inc2024

SPAD Developed in 55 nm Bipolar-CMOS-DMOS Technology Achieving Near 90% Peak PDP

Edoardo Charbon, Claudio Bruschini, Ekin Kizilkan, Pouyan Keshavarzian, Francesco Gramuglia, Won Yong Ha, Myung Jae Lee

We present a single-photon avalanche diode (SPAD) developed in 55 nm bipolar-CMOS-DMOS (BCD) technology, which achieves high photon detection probability (PDP) while its breakdown voltage is lower than 20 V. To enhance the PDP performance, the SPAD junctio ...

Ieee-Inst Electrical Electronics Engineers Inc2024

A Dual-Channel Gate Driver Design with Active Voltage Balancing Circuit for Series Connection of SiC MOSFETs

Drazen Dujic

Dual-channel gate driver is commonly utilized in the industry for accommodating the widespread use of half-bridge power modules. As wide-bandgap devices become increasingly prevalent due to their superior switching characteristics compared with conventiona ...

2024

Stability Analysis of Second-Order Harmonic Active Filters for Input-Series/Output- Parallel Solid State Transformers

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-State Transformers with Input-Series/Output- Parallel configuration offer a convenient solution for AC/DC power conversion, thanks to their modularity, scalability and flexibility. However, as known, they are affected by a second-order harmonic rippl ...

2024

Stability Analysis of Input-Series/Output-Parallel Solid-State Transformers Equipped with Second-Order Harmonic Active Power Filters

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-State Transformers with Input-Series/Output-Parallel configuration offer a convenient solution for AC/DC conversion due to their scalability and modularity. In this configuration, each module experiences a second-order harmonic ripple caused by local ...

2024

Power Aware Placement of On-Chip Voltage Regulators

Rassul Bairamkulov

In traditional power delivery networks, the on-chip supply voltage is provided by board-level converters. Due to the significant distance between the converter and the load, variations in the load current are not effectively managed, producing a significan ...

Ieee-Inst Electrical Electronics Engineers Inc2024