Posez n’importe quelle question sur les cours, conférences, exercices, recherches, actualités, etc. de l’EPFL ou essayez les exemples de questions ci-dessous.
AVERTISSEMENT : Le chatbot Graph n'est pas programmé pour fournir des réponses explicites ou catégoriques à vos questions. Il transforme plutôt vos questions en demandes API qui sont distribuées aux différents services informatiques officiellement administrés par l'EPFL. Son but est uniquement de collecter et de recommander des références pertinentes à des contenus que vous pouvez explorer pour vous aider à répondre à vos questions.
A thermal oil operated tube bundle heat exchanger within the off-gas from an electric arc furnace (EAF) was developed for supplying heat to an electricity generating system by empirical methods. In this process both the unsteady heat flux and the dust load ...
Five different grain sizes are produced in 0.17 wt% carbon steel using varying rates of cooling from austenitization temperatures. Controlled furnace cooling from 1100 °C and 950 °C produces coarse ferrite grains of 40 µm and 32 µm diameter, respectively, ...
The punching resistance of actual reinforced concrete flat slabs is potentially influenced by the compressive membrane action, which may significantly increase their resistance compared to isolated laboratory specimens. However, design codes have been deve ...
Proc. of the 10th fib International PhD Symposium in Civil Engineering, Quebec2014
A dedicated diffusion controlled precipitation model for AlMnFeSi-alloys, based on classical nucleation and growth theory, has been implemented and coupled to a phenomenological softening model accounting for the combined effect of recovery and recrystalli ...
Investigation of the microstructural evolution of Al-Mn-Fe-Si alloys during annealing after cold rolling has been carried out. The effect of microchemistry state in terms of Mn in solid solution, constituents, size and volume fraction of dispersoids, intro ...
Various thermo-mechanical treatments were applied to refine and homogenise grain size and improve mechanical properties of hot-isostatically pressed (HIP) 14%Cr ODS ferritic steel. The grain size was reduced, improving mechanical properties, tensile streng ...
During casting, thermally induced deformations give birth to ingot distortions and residual stresses. For some high strength alloys, ingot cracking can happen during casting per se or during cooling down. Ingot distortions such as rolling face pull-in, but ...
The microstructural changes occurring during drawing and ageing in pearlitic steel wires have been studied using the thermoelectric power (TEP) measurements combined with atom probe tomography (APT) and differential scanning calorimetry (DSC). APT analysis ...
The mechanical behavior of partially solidified Al-Cu alloys is investigated to assess the influence of mushy zone deformation on hot tearing. For this purpose, the results of a semi-solid tensile test conducted in situ using X-ray microtomography are comp ...
Microstructural evolution of a cold-rolled Al-Mn-Fe-Si alloy during annealing was studied. Except the as-cast variant, two other different homogenizations were considered, one gave a high density of fine dispersiods providing a considerable Zener drag infl ...
