Publications associées à Procédé LD

Micromechanics of oxide inclusions in ferrous alloys

Oxide inclusions are inevitably present in steel as a direct consequence of the steelmaking process; as a result, a cubic centimetre of modern steel will generally contain about a million of these hard and brittle micrometre-sized ceramic particles. Inclus ...

EPFL2023

Structure, Oxygen Content and Electric Properties of Titanium Nitride Electrodes in TiNx/La:HfO2/TiNx Stacks Grown by PEALD on SiO2/Si

Philippe Buffat, Elena Suvorova Buffat

This work reports experimental results of the quantitative determination of oxygen and band gap measurement in the TiNx electrodes in planar TiNx top/La:HfO2/TiNx bottom MIM stacks obtained by plasma enhanced atomic layer deposition on SiO2. Methodological ...

2022

Impact of oxygen content in powders on the morphology of the laser molten tracks in preparation for additive manufacturing of silicon

Patrik Willi Hoffmann, Lucas Güniat, Marc Leparoux

Powder additive pulsed Nd:YAG laser (wavelength 1064 nm), with the aim of preparing AM of such material. The influence of oxygen content in the initial silicon powders on the continuous tracks morphology was investigated. It was found that the initial oxyg ...

ELSEVIER2020

Measurement and prediction of the transformation strain that controls ductility and toughness in advanced steels

William Curtin, Helena Van Swygenhoven, Francesco Maresca, Efthymios Polatidis

New-generation multi-phase martensitic steels derive their high strength from the body-centered cubic (BCC) phase and high toughness from transformation of the metastable face-centered cubic (FCC) austenite that transforms into martensite upon loading. In ...

PERGAMON-ELSEVIER SCIENCE LTD2020

Sequestered Chloroplasts In The Benthic Foraminifer Haynesina Germanica: Cellular Organization, Oxygen Fluxes And Potential Ecological Implications

Charlotte Madeleine Nicole Lekieffre, Emmanuelle Geslin

Haynesina germanica is a coastal benthic foraminifer known to sequester chloroplasts from benthic pennate diatoms. This study investigates its cellular organization, as well as the oxygen consumption and production rates under dark and light conditions. Th ...

2017

An Atomistic Simulation Method for Oxygen Impurities in Aluminium Based on Variable Charge Molecular Dynamics

Andreas Elsener

Impurities are known to have a significant impact on materials properties. In particular, the presence of impurities can change mechanical properties and stabilize the microstructure by reducing grain growth and recrystallization processes. In the past ato ...

EPFL2010

Influence of oxygen content on structure and properties of multi-element AlCrSiON oxynitride thin films

Alireza Karimi

Multi-element oxynitrides of type Al-Cr-Si-O-N were prepared using r.f. magnetron sputtering from Al80Cr2.5Si17.5 (at.%) target composition and O-2/(O-2+N-2) gas flow ratio between 0 and 100%. Two series of samples varying from pure nitrides to pure oxides ...

2010

Intermittent oxygen flux from the interior into the bottom boundary of lakes as observed by eddy correlation

Alfred Johny Wüest, Bernhard Wehrli

Turbulent oxygen transport from the overlying stratified water column into the bottom boundary layer (BBL) on the slope of a medium-sized lake was investigated using the eddy correlation (EC) technique. The seicheinduced oscillatory flow of the BBL, with a ...

American Society of Limnology and Oceanography2008

Tubular La0.7Ca0.3Fe0.85 Co0.15O3-δPerovskite Membranes, Part II: Performance and Stability

Jan Van Herle, Stefan Diethelm

Oxygen permeability through the tubular La0.7Ca0.3Fe0.85 Co0.15O3-δ perovskite membrane prepared by thermoplastic extrusion was measured in the temperature range from 800° to 1040°C in an air/argon gradient, and compared with the oxygen permeability of pla ...

2006