Ammonia trace measurements at ppb level based on near-IR photoacoustic spectroscopy
Publications associées (49)
Graph Chatbot
Chattez avec Graph Search
Posez n’importe quelle question sur les cours, conférences, exercices, recherches, actualités, etc. de l’EPFL ou essayez les exemples de questions ci-dessous.
AVERTISSEMENT : Le chatbot Graph n'est pas programmé pour fournir des réponses explicites ou catégoriques à vos questions. Il transforme plutôt vos questions en demandes API qui sont distribuées aux différents services informatiques officiellement administrés par l'EPFL. Son but est uniquement de collecter et de recommander des références pertinentes à des contenus que vous pouvez explorer pour vous aider à répondre à vos questions.
This work develops an adaptive sigma-delta modulator that is based on adapting the quantizer step-size using estimates of the quantizer input rather than the modulator input. The adaptive modulator with a first-order noise shaping filter is shown to be bou ...
The measurement of the tokamak plasma ion temperature can be obtained by collective Thomson scattering. This method requires a far infrared laser to achieve useful spatial resolution for typical tokamak plasma parameters. The very low Thomson scattering cr ...
Photoplethysmography (PPG) enables wearable vitals monitoring. Nevertheless, it is still limited by the LEDs driving current in the range of mA. We present a PPG sensor integrating an array of dedicated pinned-photodiodes (PPD) with the full readout chain ...
We investigated the effect of the phase noise of fiber amplifiers on the linewidth of the amplified signal. We used three different sources as input signal, with linewidth between 5 kHZ and 18 GHz. We did not observe any spectral broadening of the signal l ...
We have improved the sensitivity and signal-to-noise ratio of a luminescence upconversion experiment, using a charge-coupled device (CCD) as the detector. We show experimentally and numerically that the bandwidth of a 1-mm-thick beta-barium berate crystal ...
A general method is described for selecting and optimizing a gas mixt. which isolates the amplifier stages of a CO2 laser chain. The isolation increases the useful energy extd. by eliminating self-oscillation. The performance of an optimized nonsatg. gas m ...
Solar blind metal-semiconductor-metal detectors have been fabricated based on AlGaN grown on Si by molecular beam epitaxy. Some devices were fabricated by electron beam lithography, We present the device characterization and performance, that includes a no ...
We report on the experimental results of a dual-stage amplifier combining a Nd-doped double-clad fiber and a Nd-doped YAG crystal. We obtained up to 3.5-W single-mode single-frequency output power with 28-dB gain. This is, to the best of our knowledge, the ...
Pump and probe measurements with femtosecond resolution are performed on a gain-clamped semiconductor optical amplifier, a structure that contains a lasing mode. The corresponding relaxation oscillations are observed in the temporal gain recovery of the am ...