Measurement of Mechanical Coherency Temperature and Solid Volume Fraction in Al-Zn Alloys Using In Situ X-ray Diffraction During Casting
Graph Chatbot
Chattez avec Graph Search
Posez n’importe quelle question sur les cours, conférences, exercices, recherches, actualités, etc. de l’EPFL ou essayez les exemples de questions ci-dessous.
AVERTISSEMENT : Le chatbot Graph n'est pas programmé pour fournir des réponses explicites ou catégoriques à vos questions. Il transforme plutôt vos questions en demandes API qui sont distribuées aux différents services informatiques officiellement administrés par l'EPFL. Son but est uniquement de collecter et de recommander des références pertinentes à des contenus que vous pouvez explorer pour vous aider à répondre à vos questions.
Recent results of directional solidification experiments with Fe-Co alloys were not consistent with the presently accepted peritectic phase diagram. Therefore, the Fe-rich part of this phase diagram was re-examined. High-temperature gradient plane front so ...
Amorphous solids yield at a critical value Sigma(c) of the imposed stress Sigma through a dynamical phase transition. While sharp in athermal systems, the presence of thermal fluctuations leads to the rounding of the transition and thermally activated flow ...
We provide a comprehensive quantitative analysis of localized and extended topological defects in the steady state of 2D passive and active repulsive Brownian disk systems. We show that, both in and out-of-equilibrium, the passage from the solid to the hex ...
Materials composed of elements from the third and fifth columns of the periodic table display a very rich behavior, with the phase diagram usually containing a metallic liquid phase and a polar semiconducting solid. As a consequence, it is very hard to ach ...
Laser powder-bed fusion (LPBF) is an additive manufacturing (AM) process that uses a laser to selectively melt a powder bed. This process can build dense samples with complicated geometries from a wide variety of metallic alloys. In this thesis, LPBF of al ...
The potential of underground CO2 storage relies on the sealing efficiency of an overlaying caprock that acts as a geological barrier. Shales are considered as potential caprock formations thanks to their favourable hydro-mechanical properties. In this work ...
Amorphous solids are structurally disordered. They are very common and include glasses, colloids, and granular materials, but are far less understood than crystalline solids. Key aspects of these materials are controlled by the presence of excitations in w ...
In 1952, Frank (Proc R Soc Lond Ser-Math Phys Sci 215:43-46, 1952) already postulated that Icosahedral Short Range Order (ISRO) of atoms in the liquid could possibly explain the large nucleation undercoolings measured in metallic alloys by Turnbull and Fis ...
It has been discovered quite recently that Icosahedral Short-Range Order (ISRO) of atoms in the liquid phase of metallic alloys surrounding some trace elements added to the melt can influence both the nucleation and growth of the primary phase. In this wor ...
Metal Additive Manufacturing (AM) technologies have enabled the manufacturing of parts with complex geometries that were previously not feasible with conventional manufacturing. Unfortunately, many commercial engineering alloys (with the exception of alloy ...
