Publication

Predicting the dynamic behavior of Francis turbine generating units

Publications associées (116)

Graph Chatbot

Chattez avec Graph Search

Posez n’importe quelle question sur les cours, conférences, exercices, recherches, actualités, etc. de l’EPFL ou essayez les exemples de questions ci-dessous.

AVERTISSEMENT : Le chatbot Graph n'est pas programmé pour fournir des réponses explicites ou catégoriques à vos questions. Il transforme plutôt vos questions en demandes API qui sont distribuées aux différents services informatiques officiellement administrés par l'EPFL. Son but est uniquement de collecter et de recommander des références pertinentes à des contenus que vous pouvez explorer pour vous aider à répondre à vos questions.

Connectez-vous pour utiliser Chat avec Graph Search

Improving hydropower flexibility by synergizing independently managed utilities

Giovanni De Cesare, Pedro Filipe De Almeida Manso, Sabine Chamoun, Vincent Gaertner, Steve Crettenand

Increasing the flexibility of hydropower allows operators to produce at optimal time ranges, not only dependent on the demand flow but also on the price trends. However, the possibility to improve hydropower flexibility can be hindered when assets are mana ...

Hydropower&Dams, Aqua Media International2019

, , ,

Francis turbines operating at off-design conditions experience the development of unfavourable cavitation flows in the draft tube at the runner outlet, which induce pressure pulsations and hydro-acoustic resonances in the worst cases. The assessment of hyd ...

2019

Pumps running as turbines are pointed out as a cost-effective solution for energy recovery in pressurised water supply systems. However, these hydraulic machines feature low efﬁciency under variable discharge operation due to the lack of an inlet ﬂow contr ...

2019

, ,

Based on the Water Protection Act of 2013, severe issues caused by the rapid change of water discharge (hydropeaking) must be reduced by operators of hydroelectric power plants in Switzerland. Therefore, a new generation of regulating basins is under const ...

2019

, , , ,

Francis turbines operating at part load conditions typically experience a cavitation vortex rope immediately at the runner outlet. As the compliance of this cavitation flow is much higher than the one in cavitation-free conditions, a decrease in the value ...

2018

Model testing beyond the scope of International Standards: an outlook.

François Avellan, Loïc Andolfatto

The roles of hydropower plants within the energy system has been evolving during the last two decades. The potential to provide ancillary services to the grid is often harnessed, leading to a major change in hydropower plants operations. Ancillary services ...

2018

Monitoring a Francis Turbine Operating Conditions

François Avellan, Loïc Andolfatto, Joao Gomes Pereira Junior

Francis turbines are designed for a specific set of operating conditions that is particular to each hydropower plant site. It allows this type of turbine to extract as much hydraulic power as possible, as long as they are operating in the right conditions. ...

2018

Pumps running as turbines for energy recovery in water supply systems

João Nuno Gomes Borga Delgado

Pressurised water supply systems are infrastructures that offer a potential for energy recovery in locations where these systems operate with an excessive pressure. The integration of micro hydropower plants for energy recovery is a challenge, as these sys ...

EPFL2018

Experimental investigation of the sloshing motion of the water free surface in the draft tube of a Francis turbine operating in synchronous condenser mode

François Avellan, Elena Vagnoni, Arthur Tristan Favrel, Loïc Andolfatto

Hydropower units may be required to operate in condenser mode to supply reactive power. In this operating mode, the water level in the turbine or pump-turbine is decreased below the runner by closing the guide vanes and injecting pressurized air. While ope ...

2018

Use of compact Laser Doppler Velocimetry in reduced scale model testing of hydraulic machines

François Avellan, Vincent Berruex, Andres Müller, Loïc Andolfatto, Masashi Sakamoto

Laser based flow survey methods such as Laser Doppler Velocimetry (LDV) or Particle Image Velocimetry (PIV) have long been used for studying the flow in hydraulic machines. Even if the results have crucially improved our understanding of potentially destab ...

2018