Êtes-vous un étudiant de l'EPFL à la recherche d'un projet de semestre?
Travaillez avec nous sur des projets en science des données et en visualisation, et déployez votre projet sous forme d'application sur Graph Search.
Side-by-side hybrid textiles are an intermediate step for the production of fibre-reinforcedthermoplastic composites. Press moulding these materials combining reinforcing fibre textiles andthermoplastic matrix textiles or flexible layers is a promising method to produce high-end fibre-reinforced thermoplastic composites parts with complex geometry at relatively short cycle timesand lower costs. Since most of the established manufacturing methods for fibre-reinforced ther-moplastic composites can only produce parts with limited complexity, press moulding of hybridtextiles could broaden the manufacturing capabilities and offer a whole new set of possibilities.However, the current lack of three-dimensional consolidation model prevents the establishment ofthis technology, as appropriate design and process parameters cannot be determined and defectformation cannot be predicted.This thesis presents the development of a three-dimensional consolidation model for pressmoulding of hybrid textiles. First, a literature review is presented to identify the limits of modelsaddressing effects relevant for consolidation. A model for the stress response of textile stacks,which is an effect taking place during consolidation, is validated and a numerical approach tocharacterize the model parameters is presented. Then, a novel consolidation model for hybridtextiles including air entrapment, dissolution and diffusion is developed and validated experimen-tally using glass reinforcements and polypropylene or polyethylene matrices. Direct measurementvalidates the model of Gebart for permeability, a key model parameter, at very high fibre vol-ume fractions and it is shown that entrapped air significantly influences impregnation. Finally,the model is extended in three-dimensions with some restrictions by considering a free-form platewith non-uniform thickness. By adopting a unit-cell approach with three-phase flow, it is possi-ble to take into account the volume change resulting from matrix flow and impregnation, and byadopting a homogenization method the computational challenges of a full-scale simulation canbe bypassed. This novel consolidation model provides insights to explain the fiber movementin non-uniform thickness plates, enables part and process optimization, and paves the way forhigh-quality composite part production.
Jean-Philippe Hogge, Francisco Sanchez
Josephine Anna Eleanor Hughes, Max Mirko Polzin