A stepper is a device used in the manufacture of integrated circuits (ICs) that is similar in operation to a slide projector or a photographic enlarger. Stepper is short for step-and-repeat camera. Steppers are an essential part of the complex process, called photolithography, which creates millions of microscopic circuit elements on the surface of silicon wafers out of which chips are made. These chips form the heart of ICs such as computer processors, memory chips, and many other devices.
The stepper emerged in the late 1970s but did not become widespread until the 1980s. This was because it was replacing an earlier technology, the mask aligner. Aligners imaged the entire surface of a wafer at the same time, producing many chips in a single operation. In contrast, the stepper imaged only one chip at a time, and was thus much slower to operate. The stepper eventually displaced the aligner when the relentless forces of Moore's Law demanded that smaller feature sizes be used. Because the stepper imaged only one chip at a time it offered higher resolution and was the first technology to exceed the 1 micron limit. The addition of auto-alignment systems reduced the setup time needed to image multiple ICs, and by the late 1980s, the stepper had almost entirely replaced the aligner in the high-end market.
The stepper was itself replaced by the step-and-scan systems (scanners) which offered an additional order of magnitude resolution advance, and work by scanning only a small portion of the mask for an individual IC, and thus require much longer operation times than the original steppers. These became widespread during the 1990s and essentially universal by the 2000s. Today, step-and-scan systems are so widespread that they are often simply referred to as steppers.
1957: Attempts to miniaturize electronic circuits started back in 1957 when Jay Lathrop and James Nall of the U.S. Army's Diamond Ordnance Fuse Laboratories were granted a US2890395A patent for a photolithographic technique that could be used to deposit thin-film metal strips that in turn used to connect discrete transistors on a ceramic plate.
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Micro- and nanofabrication can be taught to students and professionals by textbooks and ex-cathedra lectures, but the real learning comes from seeing the manufacturing steps as they happen. This MOOC
Digital IC Design presents the fundamentals of digital integrated circuit design. The methods and techniques aiming at the fabrication and development of digital integrated circuits are reviewed, the
Covers the process integration in semiconductor fabrication, including twin-well process, isolation methods, threshold voltage adjustment, and silicide formation.
Extreme ultraviolet lithography (also known as EUV or EUVL) is an optical lithography technology used in semiconductor device fabrication to make integrated circuits (ICs). It uses extreme ultraviolet (EUV) wavelengths near 13.5 nm, using a laser-pulsed tin (Sn) droplet plasma (Sn ions in the ionic states from Sn IX to Sn XIV give photon emission spectral peaks around 13.5 nm from 4p64dn - 4p54dn+1 + 4dn-14f ionic state transitions.), to produce a pattern by using a reflective photomask to expose a substrate covered by photoresist.
This semester project aimed at simulating two approaches for low temperature dependence of resonance frequency of resonators. The first one consists in using AT-cut quartz as the resonator’s material. The AT-cut quartz wafers are made using a 35° angle wit ...
PET reconstruction algorithms have long relied on sinogram rebinning. However, as detectors grow smaller in a recent wave of cutting-edge scanners, individual sensors no longer accrue hundreds of photons. Instead, most detect a single photon or none at all ...
New York2023
During this project, the microfabrication of Hafnium Carbide (HfC) was investigated. Multiple tools were considered and tested for their compatibility and effectiveness when working with HfC. The main method of choice for the machining of HfC thin films wa ...