Are you an EPFL student looking for a semester project?
Work with us on data science and visualisation projects, and deploy your project as an app on top of Graph Search.
Concept
Classic RISC pipeline
Summary
In the history of computer hardware, some early reduced instruction set computer central processing units (RISC CPUs) used a very similar architectural solution, now called a classic RISC pipeline. Those CPUs were: MIPS, SPARC, Motorola 88000, and later the notional CPU DLX invented for education.
Each of these classic scalar RISC designs fetches and tries to execute one instruction per cycle. The main common concept of each design is a five-stage execution instruction pipeline. During operation, each pipeline stage works on one instruction at a time. Each of these stages consists of a set of flip-flops to hold state, and combinational logic that operates on the outputs of those flip-flops.
The instructions reside in memory that takes one cycle to read. This memory can be dedicated to SRAM, or an Instruction Cache. The term "latency" is used in computer science often and means the time from when an operation starts until it completes. Thus, instruction fetch has a latency of one clock cycle (if using single-cycle SRAM or if the instruction was in the cache). Thus, during the Instruction Fetch stage, a 32-bit instruction is fetched from the instruction memory.
The Program Counter, or PC is a register that holds the address that is presented to the instruction memory. The address is presented to instruction memory at the start of a cycle. Then during the cycle, the instruction is read out of instruction memory, and at the same time, a calculation is done to determine the next PC. The next PC is calculated by incrementing the PC by 4, and by choosing whether to take that as the next PC or to take the result of a branch/jump calculation as the next PC. Note that in classic RISC, all instructions have the same length. (This is one thing that separates RISC from CISC ). In the original RISC designs, the size of an instruction is 4 bytes, so always add 4 to the instruction address, but don't use PC + 4 for the case of a taken branch, jump, or exception (see delayed branches, below).
Official source
About this result
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.