Fe, Co, and Ni Ions Promote the Catalytic Activity of Amorphous Molybdenum Sulfide Films for Hydrogen Evolution

Molybdenum sulfide materials had been shown as promising non-precious catalysts for hydrogen evolution. This paper describes the study of the promotional effect of certain transition metal ions on the activity of amorphous MoS3 films. Ternary metal sulfide films, M-MoS3 (M = Mn, Fe, Co, Ni, Cu, Zn), have been prepared by cyclic voltammetry of aqueous solutions containing MCl2 and (NH4)2[MoS4]. Whereas the Mn-, Cu-, and Zn-MoS3 films show similar or only slightly higher catalytic activity as the MoS3 film, the Fe-, Co-, and Ni-MoS3 films are significantly more active. The promotional effects of Fe, Co, and Ni ions exist under both acidic and neutral conditions, but the effects are more pronounced under neutral conditions. Up to a 12-fold increase in exchange current density and a 10-fold increase in the current density at an overpotential of 150 mV are observed at pH = 7. It is shown that Fe, Co, and Ni ions promote the growth of the MoS3 films, resulting a high surface area and a higher catalyst loading. These changes are the main contributor to the enhanced activity at pH = 0. However, at pH = 7, Fe, Co, and Ni ions appear to also increase the intrisinc activity of the MoS3 film.

Amorphous Molybdenum Sulfide Films as Hydrogen Evolution Catalysts in Water

Daniel Andreas Merki

Molecular hydrogen is a promising candidate to replace fossil fuels as the energy carrier. Hydrogen does not exist in its molecular form on earth and must therefore be generated, starting from hydrogen-rich compounds. Water would be a renewable resource for hydrogen. It can be split into oxygen and hydrogen. Water splitting, however, needs electrical energy. If this energy is produced from renewable resources, such as solar or wind power, water splitting would be a sustainable and green process. One key step in water splitting is the reduction of protons to form hydrogen. To achieve a high efficiency in this reaction, catalysts are required. This dissertation is devoted to the development of hydrogen evolution catalysts that are made of earth-abundant and inexpensive materials. First, transition metal complexes of tetrathiotungstate and tetrathiomolybdate were studied as potential homogeneous catalysts for hydrogen evolution in organic or aqueous solutions (chapter 1). The redox activity of these complexes was investigated by cyclic voltammetry in the absence and presence of an acid in organic solutions. The first reduction peak of (Pr4N)2[Ni(MoS4)2] became more intense and was shifted to less negative potentials upon addition of an acid, e.g. p-cyanoanilinium tetrafluoroborate. This was considered as a sign for catalytic proton reduction. Electrolysis of a solution containing (Pr4N)2[Ni(MoS4)2] and an acid produced hydrogen. However, the complex turned out to be a precursor of the real catalytically active species, which was deposited on the working electrode’s surface during the electrochemical experiment. Consecutive cyclic voltammetric scans were found to be a good method to deposit the catalytically active film in a controllable manner from an aqueous solution of (Pr4N)2[Ni(MoS4)2]. Furthermore, a catalytically active film could be deposited from a solution of MoS42-, i.e. in the absence of Ni2+. Chapter 2 describes the investigation and characterization of films made using MoS42- as the precursor. The films consist of amorphous molybdenum sulfide. They are efficient hydrogen evolution catalysts in water. The films were characterized by XPS and electron microscopy. Whereas the pre-catalysts could be MoS3 or MoS2, the active form of the catalysts was identified as amorphous MoSx, with x close to 2. Significant geometric current densities were achieved at low overpotentials (e.g., ca. 15 mA/cm2 at η = 200 mV) using these catalysts. The catalysis was compatible with a wide range of pH values. The current efficiency for hydrogen production was quantitative. A Tafel slope of 39 mV/dec was observed, suggesting a rate-determining Heyrovsky step. The turnover frequency per active site was estimated.

EPFL2012

Electrochemical incineration of chloromethylphyenoxy herbicides in acid medium by anodic oxidation with boron-doped diamond electrodes

Christos Comninellis, Béatrice Marselli Fuerer, Pierre-Alain Michaud

The electrochemical degradation of saturated solutions of herbicides 4-chloro-2-methylphenoxyacetic acid, 2-(4-chlorophenoxy)-2-methylpropionic acid and 2-(4-chloro-2-methylphenoxy)propionic acid in 1 M HClO4 on a boron-doped diamond (BDD) thin film anode has been studied by chronoamperometry, cyclic voltammetry and bulk electrolysis. At low anodic potentials polymeric products are formed causing the fouling and deactivation of BDD. This is reactivated at high potentials when water decomposes producing hydroxyl radical as strong oxidant of organics. Electrolyses in a batch recirculation system at constant current density ≥8 mA cm−2 yielded overall decontamination of all saturated solution. The effect of current density and herbicide concentration on the degradation rate of each compound, the specific charge required for its total mineralization and instantaneous current efficiency have been investigated. Experimental results have been compared with those predicted by a theoretical model based on a fast anodic oxidation of initial herbicides, showing that at 30 mA cm−2 their degradation processes are completely controlled by mass transfer. Kinetic analysis of the change of herbicide concentration with time during electrolysis, determined by high-performance liquid chromatography, revealed that all compounds follow a pseudo first-order reaction. Aromatic intermediates and generated carboxylic acids have been identified using this technique and a general pathway for the electrochemical incineration of all herbicides on BDD is proposed.

2006

Recent developments of molybdenum and tungsten sulfides as hydrogen evolution catalysts

Xile Hu, Daniel Andreas Merki

Recent work shows that nanoparticulate and amorphous molybdenum and tungsten sulfide materials are active catalysts for hydrogen evolution in aqueous solution. These materials hold promise for applications in clean hydrogen production technologies. In this perspective, the syntheses, structures and catalytic activities of nanoparticulate MoS2 and WS2, incomplete cubane-type [Mo3S4]4+ and amorphous MoSx films are summarized, compared, and discussed.

Royal Society of Chemistry2011

Amorphous Molybdenum Sulfide Films as Hydrogen Evolution Catalysts in Water

Daniel Andreas Merki

EPFL2012