Christian EnzChristian C. Enz (M84, S'12) received the M.S. and Ph.D. degrees in Electrical Engineering from the EPFL in 1984 and 1989 respectively. From 1984 to 1989 he was research assistant at the EPFL, working in the field of micro-power analog IC design. In 1989 he was one of the founders of Smart Silicon Systems S.A. (S3), where he developed several low-noise and low-power ICs, mainly for high energy physics applications. From 1992 to 1997, he was an Assistant Professor at EPFL, working in the field of low-power analog CMOS and BiCMOS IC design and device modeling. From 1997 to 1999, he was Principal Senior Engineer at Conexant (formerly Rockwell Semiconductor Systems), Newport Beach, CA, where he was responsible for the modeling and characterization of MOS transistors for the design of RF CMOS circuits. In 1999, he joined the Swiss Center for Electronics and Microtechnology (CSEM) where he launched and lead the RF and Analog IC Design group. In 2000, he was promoted Vice President, heading the Microelectronics Department, which became the Integrated and Wireless Systems Division in 2009. He joined the EPFL as full professor in 2013, where he is currently the director of the Institute of Microengineering (IMT) and head of the Integrated Circuits Laboratory (ICLAB).He is lecturing and supervising undergraduate and graduate students in the field of Analog and RF IC Design at EPFL. His technical interests and expertise are in the field of very low-power analog and RF IC design, semiconductor device modeling, and inexact and error tolerant circuits and systems.He has published more than 200 scientific papers and has contributed to numerous conference presentations and advanced engineering courses. Together with E. Vittoz and F. Krummenacher he is one of the developer of the EKV MOS transistor model and the author of the book "Charge-Based MOS Transistor Modeling - The EKV Model for Low-Power and RF IC Design" (Wiley, 2006). He has been member of several technical program committees, including the International Solid-State Circuits Conference (ISSCC) and European Solid-State Circuits Conference (ESSCIRC). He has served as a vice-chair for the 2000 International Symposium on Low Power Electronics and Design (ISLPED), exhibit chair for the 2000 International Symposium on Circuits and Systems (ISCAS) and chair of the technical program committee for the 2006 European Solid-State Circuits Conference (ESSCIRC). Since 2012 he has been elected as member of the IEEE Solid-State Circuits Society (SSCS) Administrative Commmittee (AdCom). He is also Chair of the IEEE SSCS Chapter of Switzerland.
Claudio BruschiniClaudio Bruschini holds an MSc in high energy physics from the University of Genova and a PhD in Applied Sciences from the Vrije Universiteit Brussel (VUB). He started his career with INFN (Italy, 1993), in the WA92 CERN collaboration (particle physics), and then moved to CERN as a Fellow in the European GP-MIMD2 project, attached to the NA48 collaboration (particle physics, parallel programming, 1994-1995). He then started his close collaboration with EPFL, first in the DeTeC (Demining Technology Center) project (sensors for landmine detection/humanitarian demining, 1996-1997). After DeTeC's end, he started the first of a series of fruitful collaborations with the Vrije Universiteit Brussel (VUB) on humanitarian demining related R&D (1998). This was followed by the EUDEM survey project (The European Union in Humanitarian Demining, 1998), the EUDEM2 three year EC sponsored support measure (www.eudem.info, 2001-2004), and the DELVE support action (www.delve.vub.ac.be, 2007). In parallel he started working within the EPFL's AQUA group (Advanced Quantum Architectures, Edoardo Charbon), on topics as diverse as ultrasonic sensors for in-air application, optical 3D and high speed 2D sensing, sensor networks, or tracking/motion capture systems, in particular for the preparation of research projects. This culminated in the European MEGAFRAME (www.megaframe.eu, FP6, 2006-2010, SPAD arrays and related in-pixel time stamping electronics in deep submicron CMOS technology) and SPADnet (www.spadnet.eu, FP7, 2010-2014, networked SPAD arrays for Positron Emission Tomography) projects, coordinated by EPFL-AQUA. As from 2009 he also worked with Dario Floreano on the management of the CURVACE Curved Artificial Compound Eyes FP7 project (www.curvace.org), coordinated by EPFL-LIS. He was also active with CHUV (Lausanne University Hospital) within EndoTOFPET-US (endoscopic PET) as well as on a CTI project devoted to the development of a new hand-held standalone tool for tracer-guided medical procedures. In 2014 he had also the pleasure of joining the EPFL ICLAB of Christian Enz during its ramp-up phase, collaborating on device related topics (SNF GigaRadMOST) and biomedical R&D (NanoTera WiseSkin). Claudio is now fully with EPFL’s Advanced Quantum Architecture (AQUA). He has also been active as independent scientific consultant, under the label CBR Scientific Consulting, on the preparation of (European) R&D project proposals and the execution of individual studies, and worked in 2006 for a local start-up as operations manager and R&D advisor.... but this is another story. An unauthorized early biography is available at http://lami.epfl.ch/team/claudiob/... Sandro CarraraSandro Carrara is an IEEE Fellow for his outstanding record of accomplishments in the field of design of nanoscale biological CMOS sensors. He is also the recipient of the IEEE Sensors Council Technical Achievement Award in 2016 for his leadership in the emerging area of co-design in Bio/Nano/CMOS interfaces. He is a Professor of the EPFL in Lausanne (Switzerland), and head of the "Bio/CMOS Interfaces" (BCI) research group. He is former professor of optical and electrical biosensors at the Department of Electrical Engineering and Biophysics (DIBE) of the University of Genoa (Italy) and former professor of nanobiotechnology at the University of Bologna (Italy). He holds a PhD in Biochemistry & Biophysics from University of Padua (Italy), a Master degree in Physics from University of Genoa (Italy), and a diploma in Electronics from National Institute of Technology in Albenga (Italy). His scientific interests are on electrical phenomena of nano-bio-structured films, and include CMOS design of biochips based on proteins and DNA. Along his carrier, he published 7 books, one as author with Springer on Bio/CMOS interfaces and, more recently, a Handbook of Bioelectronics with Cambridge University Press. He has more than 250 scientific publications and is author of 13 patents. He is now Editor-in-Chief of the IEEE Sensors Journal, the largest journal among 2019 IEEE publications; he is also founder and Editor-in-Chief of the journal BioNanoScience by Springer, and Associate Editor of IEEE Transactions on Biomedical Circuits and Systems. He is a member of the IEEE Sensors Council and his Executive Committee. He was a member of the Board of Governors (BoG) of the IEEE Circuits And Systems Society (CASS). He has been appointed as IEEE Sensors Council Distinguished Lecturer for the years 2017-2019, and CASS Distinguished Lecturer for the years 2013-2014. His work received several international recognitions: several Top-25 Hottest-Articles (2004, 2005, 2008, 2009, and two times in 2012) published in highly ranked international journals such as Biosensors and Bioelectronics, Sensors and Actuators B, IEEE Sensors journal, and Thin Solid Films; a NATO Advanced Research Award in 1996 for the original contribution to the physics of single-electron conductivity in nano-particles; six Best Paper Awards at the IEEE Sensors Conference 2019 (Montreal) in 2019, Conferences IEEE NGCAS in 2017 (Genoa), MOBIHEALTH in 2016 (Milan), IEEE PRIME in 2015 (Glasgow), in 2010 (Berlin), and in 2009 (Cork); three Best Poster Awards at the EMBEC Conference in 2017 (Tampere, Finland), Nanotera workshop in 2011 (Bern), and NanoEurope Symposium in 2009 (Rapperswil). He also received the Best Referees Award from the journal Biosensor and Bioelectronics in 2006. From 1997 to 2000, he was a member of an international committee at the ELETTRA Synchrotron in Trieste. From 2000 to 2003, he was scientific leader of a National Research Program (PNR) in the filed of Nanobiotechnology. He was an internationally esteemed expert of the evaluation panel of the Academy of Finland in a research program for the years 2010-2013. He has been the General Chairman of the Conference IEEE BioCAS 2014, the premier worldwide international conference in the area of circuits and systems for biomedical applications
Farzan JazaeriFarzan Jazaeri received his M.Sc. degree in 2009 from University of Tehran and his Ph.D. in electronic engineering from EPFL in 2015. He has been serving as Research Scientist at EPFL since 2015 and Senior RD Semiconductor Device Engineer in the Swatch Company since 2019.He is a recipient of the 2018 Electron Devices Society George E. Smith Award, the best talk award from MIXDES 2019 and the best paper awards from ESSDERC2018 and ESSDERC2019, and several other academic awards. He is also awarded an advanced Swiss National Science Foundation grant for two years fellowship in MIT and NASA. His doctoral thesis was recognized to be eligible for the IBM award in 2017. Dr. Jazaeri is currently research scientist and project leader in high level of international scientific collaborative activities at EPFL. His research activities on solid-state physics are focused on creation of the cryogenic temperature infrastructure necessary to operate the qubits for quantum computations(MOSQUITO), radiation-induced damages in advanced devices for the future high energy physics experiments at CERN (GigaRadMOST), Pinned Photodiodes for CIS, and modeling and characterization AlGaN-GaN heterostructure in collaboration with IMEC. Together with Dr. Sallese, he is the lead developer of EPFL HEMT MODEL for GaN HEMTs. He fully developed a new model (EPFL-JL Model) for the so-called nanowire FETs and was invited by Cambridge University Press to write a book on junctionless nanowire FETs, emerging nanoelectronic devices, already published since 2018. He serves as lead editor and reviewer for several scientific journals. He has been an invited keynote speaker at several international conferences and events. He is invited to MIXDES 2019 as a keynote speaker to address quantum bits and quantum computing architecture.From Jun 2009 to February 2010, he worked on designing and implementing SD/HD broadcast systems with SAMIM-RAYANEH Co., Tehran, Iran. Between March 2010 and November 2011 he worked as a SCADA expert in Tehran Regional Electric Co. (TREC), Tehran, Iran. From September 2010 to December 2011, he continued his research activities in nano-electronics in Tehran, Iran. In December 2011, he joined to Electron Device Modelling and Technology Lab (EDLab) and pursued his Ph.D. degree at EPFL. In 2015, he received his Ph.D. from Microsystems and Microelectronics department, Integrated Systems Laboratory (STI/IC) at EPFL, Lausanne, Switzerland.
Assim BoukhaymaAssim Boukhayma was born in Rabat, Morocco, on February 5, 1988. He received the graduate engineering degree (D.I.) in information and communication technology and the M.Sc. in microelectronics and embedded systems architecture from Telecom-Bretagne, Brest, France, in 2013. He is currently working toward the Ph.D. at Ecole Polytechnique Federale de Lausanne (EPFL), Neuchatel, Switzerland and Commissariat a l Energie Atomique (CEA-LETI), Grenoble, France with Prof. Christian Enz on the subject of CMOS image sensors.
From 2011 to 2012, he worked with Bouygues-Telecom as a Telecommunication Radio Junior Engineer. In 2013, he did his M.Sc. Internship at Commissariat a l Energie Atomique (CEA-LETI) on the design of a low noise CMOS THz camera and published this work at the 40th European Solid-State Circuits Conference (ESSCIRC).
Gian Luca BarbruniGian Luca Barbruni achieved his BSc and his MSc in Biomedical Engineering with specialisation in Biomedical Instrumentation at the Politecnico di Torino in 2017 and 2019, respectively.During his master thesis, supervised by Prof. Danilo Demarchi from Politecnico di Torino and titled “Body Dust: Feasibility study on signal transmission for sub-100μm-size active wireless biosensors”, he spent a semester of research at Integrated Circuit Laboratory (ICLAB) of Neuchâtel under the supervision of Prof. Sandro Carrara from École Polytechnique Fédérale de Lausanne (EPFL), Switzerland. He discusses about the feasibility on creating an UltraSound (US) communication circuit to wirelessly transmit outside the body diagnostic information from multiplexed biosensors chip built on the top layer of a drinkable CMOS “Body Dust” cube. The results of the feasibility study have been published showing promising results with sub-10 µW of power consumption and a total chip area of 43 x 44 µm2.He was a Research Assistant at the Department of Electronic Engineering (DET) of Politecnico di Torino.Actually he is conducting his PhD focusing on design and fabrication of analog and digital circuits for ultra-miniaturized CMOS for vision prosthesis, directed by Prof. Diego Ghezzi at Medtronic Chair in Neuroengineering in Geneva and co-directed by Prof. Sandro Carrara at ICLAB in Neuchâtel.
