Silicon oxide deposition for enhanced optical switching in polydimethylsiloxane-liquid crystal hybrids

We report an optical switch based on a diffraction grating by combining PDMS microstructures with a photo-responsive Nematic Liquid Crystal (NLC). The grating was realized via replica molding and was subsequently coated with a thin SiO layer. SiO induced a full planar alignment of the liquid crystal. The induced parallel alignment of the LC reduces the response time of the structure by approximately an order of magnitude compared to the same structures without SiO. We explored the effect of the pump intensity on the transmission properties and time response of the switch and identified a strong dependence on the probe polarization, due to the full planar alignment in this structure. The aforementioned inclusion of the SiO layer enables enhanced performance of optical devices based on the fusion of nematogens with soft and flexible substrates. (C) 2011 Optical Society of America

All-optical switching in an optofluidic polydimethylsiloxane: Liquid crystal grating defined by cast-molding

Julien Cuennet, Luciano De Sio, Demetri Psaltis, Andreas Vasdekis

We report an optofluidic photoswitchable grating, based on a polydimethylsiloxane periodic structure on a glass substrate, separated by a thin liquid crystal film. The polydimethylsiloxane microstructure was realized via high resolution replica molding and was employed to both confine and align a photosensitive nematic liquid crystal. In the absence of any surface treatment, the liquid crystal exhibited homeotropic alignment. By inducing planar alignment on the glass substrate, a hybrid orientation of the liquid crystal was achieved, inducing polarization sensitive transmission. The photosensitivity of the liquid crystal enabled the all-optical control of the grating transmission and 20% diffraction efficiency was measured. © 2010 American Institute of Physics.

2010

Distributed sensing using polarization sensitive optical low-coherence reflectometry and fiber gratings

Dragan Coric

Optical low coherence reflectometry (OLCR) is non-destructive interferometric technique that allows measuring amplitude and phase of the light reflected from the device under test. OLCR is a powerful tool for the characterization of the various optical devices such as fiber gratings and optical waveguides. This thesis work had explored possibilities to combine the OLCR technique with fiber gratings to perform distributed strain and temperature measurements, and to develop novel sensing techniques as an alternative to classical spectral methods. Special attention is devoted to polarization sensitive measurements and techniques, and OLCR techniques that use only amplitude information, as an alternative to more complicated phase sensitive measurements. Using a polarization sensitive system two methods for the measurement of local birefringence of fiber Bragg gratings (FBG) using OLCR were developed. The first technique uses oscillations in the OLCR amplitude signal to directly obtain the beat length and the birefringence. The second method is based on the measurement of the OLCR phase and inverse scattering algorithm. Both methods were compared with birefringence obtained from spectral measurements, and very good agreement was obtained. The indirect method, based on local Bragg grating determination requires two independent measurements and mathematical reconstruction, but provides a very high spatial resolution of ≈ 25 µm. The grating length limits the minimum measurable birefringence in the direct method, but a good sensitivity of 4×10-6 was obtained, which corresponds to a Bragg wavelength shift of 4 pm. The spatial resolution is in the millimeter range in this case. The novel methods were successfully applied for the distributed measurement of birefringence of FBG under diametric load. New types of tunable devices and sensors – fiber Bragg gratings written in high attenuation fibers (HAF) were developed. Active tuning by heating was achieved by optical pumping of a pure single mode fiber without any mechanical or electrical parts, or deposited light absorption coatings. Tuning can be controlled by the applied pump power, the position of the grating, the HAF attenuation level, and the pumping configuration. The proposed design assures a high repeatability and long lifetime. Using OLCR these devices were successfully applied to measure the liquid level with a spatial resolution of 100 micrometers. Liquid level measurements that use both phase and amplitude, or only amplitude were demonstrated. The same principles could be easily applied to design other fiber grating devices (long-period, tilted etc), and sensors based on hot-wire anemometry, like flow or vacuum sensors.

EPFL2007

Building optical matter with binding and trapping forces

Gerben Boer, Guy Delacrétaz, Jean-Marc Fournier, Johann Rohner, René Salathé

Very high frequency oscillations of intense light fields interact with micron-size dielectric objects to exert dc optical forces that allow polarizable particles to levitate, to be trapped and to be bound. Such optical forces are also suitable to arrange cold atoms in optical lattices. Various assemblages of optical traps, including periodic arrays, can be constructed either with independent lasers, or with a single laser beam split into different parts later recombined by interference, as well as through the use of diffractive elements. These optical-well arrays serve as templates for writing and erasing dynamic two-dimensional and three-dimensional "optical crystals", composed of mono-dispersed polystyrene spheres in water. Subsequently, the crystals become diffractive structures themselves. The association of micro-fluidics and optical trapping allows for the formation of optical traps into micro-channels. This leads to perform microchemistry experiments, such as fluorescence detection, on individual bodies attached to trapped particles. Self-trapping due to the optical binding force relates to the interaction between different dielectric objects located in an electromagnetic field; each one reacts not only to the field of the incident beam, but also to the induced fields radiated coherently by all other particles. Optical binding strongly influences the equilibrium state and the behavior of optical crystals. It must have the potential for creating collective effects.

2004

Distributed sensing using polarization sensitive optical low-coherence reflectometry and fiber gratings

Dragan Coric

EPFL2007