Publication

III-V Nanowire Hetero-junction Tunnel FETs integrated on Si

Davide Cutaia
2016
EPFL thesis
Abstract

In the last decade the power consumption of electronic devices has increased for both static and active components. Following the Dennard's scaling rule, as long as the transistor sizes are reduced then the supply voltage (VDD) can also be scaled in order to increase the area density and maintain or improve the performances. However, scaling VDD and thus shifting the threshold voltage (Vth) of 60mV in a metal-oxide semiconductor field-effect transistor (MOSFET) increases the OFF state current (Ioff ) by a factor of 10 in the ideal case. The reason for this is that the inverse subthreshold slope (SS) in an ideal MOSFET is limited by the thermionic emission of electrons over a potential barrier, which has an intrinsic physical limit of 60mV/decade. To overcome this limit, novel device concepts have been proposed and the tunnel field-effect transistor (TFET) is one of the most promising because it resembles a MOSFET and should enable to achieve sub-60mV/dec SS, low Ioff and small VDD. The aim of this thesis is to investigate the potential of TFETs by the fabrication and characterization of InAs/Si as p-channel and InAs/GaSb as n-channel device for a complementary TFET technology. III-V nanowires are grown via metal-organic chemical vapor deposition (MOCVD) and are integrated on Si(100) substrates using a novel technique called template-assisted selective epitaxy (TASE), which enables the fabrication of vertical and lateral III-V hetero-structure TFETs. Sub-40nm nanowire cross-section InAs/Si p-TFETs and InAs/GaSb n-TFETs in-plane on Si are demonstrated for the first time. The InAs/Si p-TFETs exhibit state-of-the art performances with an ON state current (Ion) of 4uA/um at VGS=VDS=-0.5V, ON/OFF ratio of 1x10E5 with SSavg of 70-80mV/dec at room temperature. The InAs/GaSb n-TFETs have an order of magnitude larger Ion but the SS is limited by the non-optimized gate-stack on InAs channel and by the depletion of the undoped GaSb source. Different operation regimes of TFETs are investigated by temperature-dependent measurements,Wentzel-Kramers-Brillouin (WKB) modeling and TCAD simulations, indicating that the switching region for InAs/Si is dominated by the presence of traps at the hetero-junction. The abruptness of the band-edges in InAs/GaSb is studied by the extraction of the conductance slope in fabricated p-n and p-i-n tunnel diodes.

About this result
This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.
Related concepts (32)
Field-effect transistor
The field-effect transistor (FET) is a type of transistor that uses an electric field to control the flow of current in a semiconductor. FETs (JFETs or MOSFETs) are devices with three terminals: source, gate, and drain. FETs control the flow of current by the application of a voltage to the gate, which in turn alters the conductivity between the drain and source. FETs are also known as unipolar transistors since they involve single-carrier-type operation.
Transistor
A transistor is a semiconductor device used to amplify or switch electrical signals and power. It is one of the basic building blocks of modern electronics. It is composed of semiconductor material, usually with at least three terminals for connection to an electronic circuit. A voltage or current applied to one pair of the transistor's terminals controls the current through another pair of terminals. Because the controlled (output) power can be higher than the controlling (input) power, a transistor can amplify a signal.
MOSFET
The metal-oxide-semiconductor field-effect transistor (MOSFET, MOS-FET, or MOS FET) is a type of field-effect transistor (FET), most commonly fabricated by the controlled oxidation of silicon. It has an insulated gate, the voltage of which determines the conductivity of the device. This ability to change conductivity with the amount of applied voltage can be used for amplifying or switching electronic signals. A metal-insulator-semiconductor field-effect transistor (MISFET) is a term almost synonymous with MOSFET.
Show more
Related publications (151)

Active Voltage Balancing with Seamless Integration into Dual Gate Driver for Series Connection of SiC MOSFETs

Drazen Dujic, Renjie Wang

The versatility of half-bridge configuration of silicon carbide (SiC) metal-oxide-semiconductor field-effect transistor (MOSFET) power module contributes to its widespread adoption, highlighting the popularity and significance of its corresponding dual gat ...
2024

Doping Engineering for PDP Optimization in SPADs Implemented in 55-nm BCD Process

Edoardo Charbon, Claudio Bruschini, Myung Jae Lee, Feng Liu

We introduce a new family of single-photon avalanche diodes (SPADs) with enhanced depletion regions in a 55-nm Bipolar-CMOS-DMOS (BCD) technology. We demonstrate how to systematically engineer doping profiles in the main junction and in deep p-well layers ...
Piscataway2024

LiNiO Junction Gate for High-performance Enhancement-mode GaN Power Transistor

Taifang Wang

GaN metal-oxide-semiconductor high electron mobility transistors (MOS)HEMTs) offer outstanding properties for next-generation power electronics devices. The high conductivity, high voltage blocking capability, high operation frequency, and device-level int ...
EPFL2022
Show more
Related MOOCs (20)
Electronics
Introduction à l’électronique analogique- seconde partie. Fonctions linéaires de base réalisée à l’aide de transistor bipolaire.
Electronics
Introduction à l’électronique analogique- seconde partie. Fonctions linéaires de base réalisée à l’aide de transistor bipolaire.
Electronics
Introduction à l’électronique analogique- première partie. Fonctions de base réalisées à l’aide des amplificateurs opérationnels.
Show more