Power supply | EPFL Graph Search

A power supply is an electrical device that supplies electric power to an electrical load. The main purpose of a power supply is to convert electric current from a source to the correct voltage, current, and frequency to power the load. As a result, power supplies are sometimes referred to as electric power converters. Some power supplies are separate standalone pieces of equipment, while others are built into the load appliances that they power. Examples of the latter include power supplies found in desktop computers and consumer electronics devices. Other functions that power supplies may perform include limiting the current drawn by the load to safe levels, shutting off the current in the event of an electrical fault, power conditioning to prevent electronic noise or voltage surges on the input from reaching the load, power-factor correction, and storing energy so it can continue to power the load in the event of a temporary interruption in the source power (uninterruptible power

Hybrid continuous-discrete-time multi-bit delta-sigma A/D converters with auto-ranging algorithm

Sergio Pesenti

In wireless portable applications, a large part of the signal processing is performed in the digital domain. Digital circuits show many advantages. The power consumption and fabrication costs are low even for high levels of complexity. A well established and highly automated design flow allows one to benefit from the constant progress in CMOS technologies. Moreover, digital circuits offer robust and programmable signal processing means and need no external components. Hence, the trend in consumer electronics is to further reduce the part of analog signal processing in the receiver chain of wireless transceivers. Consequently, analog-to-digital converters with higher resolutions and bandwidths are constantly required. The ultimate goal is the direct digitization of radio frequency signals, where the conversion would be performed immediately after the front-end amplifier. ΔΣ-modulation-based converters have proved to be the most suitable to achieve the required performance. Switched-capacitor implementations have been widely used over the last two decades. However, recent publications and books have shown that continuous-time architectures can achieve the same performance with lower power consumption. Most designs found throughout the literature use a single- or few-bit internal quantizer with a high-order modulation. As a result, in order to achieve the resolutions and bandwidths required today, the sampling frequency must exceed 100MHz. This approach leads to non-negligible power consumption in the clock generation. Moreover, the presence of such fast squared signals is not suitable for a system-on-chip comprising radio frequency receivers. In this thesis we propose a low-power strategy relying on a large number of internal levels rather than on a high sampling frequency or modulation order. Besides, a hybrid continuous-discrete-time approach is used to take advantage of the accuracy of switched-capacitor circuits and the low power consumption of continuous-time implementation. The sensitivity to clock jitter brought about by the continuous-time stage is reduced by the use of a large number of levels. An auto-ranging algorithm is developed in this thesis to overcome the limitation of a large-size quantizer under low-voltage supply. Finally, the strategy is applied to a design example addressing typical specifications for a Bluetooth receiver with direct conversion.

EPFL2007

Analysis, modeling and design of a CMOS Super-Regenerative Receiver for implanted medical devices under square and sinusoidal quench signals

Catherine Dehollain, Naci Pekçokgüler

Medical implant devices have found widespread application in recent years. The Super-Regenerative Receiver has been one preferred architecture due to its power advantage over other architectures. We present a detailed analysis of the circuits and their equivalent models to be used in system level design of a Super-Regenerative Receiver in this paper. The design procedure is also demonstrated with a receiver design example. Designs were carried out in UMC 180 nm process with a center frequency of 416 MHz for MedRadio band. Errors between the simulation results of the proposed model and actual circuits are less than 1.6% for LNA characteristics and 7% for receiver output amplitude. 10 Mbps data rate was achieved with 432 pJ/bit energy consumption over 1.8 V power supply. The study is concluded with the simulation results of the circuits and the equivalent models.

ELSEVIER SCIENCE BV2019

Hybrid continuous-discrete-time multi-bit delta-sigma A/D converters with auto-ranging algorithm

Sergio Pesenti

EPFL2007